No abstract

Temporary anchorage devices (TADs) have been introduced into orthodontic clinical practice in order to allow tooth movements while avoiding strain on adjacent teeth. Miniscrews are available in the market with different diameters and materials. Accordingly, the purpose of the present report was to measure and compare the forces to bend and fracture different mini implants. Ti-6Al-4V titanium and stainless steel TADs of different manufacturers (Spider ScrewHDC; Mini Implants–Leone; Benefit–Orteam; Storm–Kristal) were evaluated. Two different diameters (1.5 mm and 2.0 mm) were tested. The sample included 10 unused specimens for each group, blocked in an Instron Universal Testing Machine, and a shear load was applied at the neck of the miniscrew. The force to bend the miniscrew was measured at 0.1 mm and 0.2 mm deflections. Also, the maximum force before screw fracture was recorded. Data were submitted for statistical analysis. Results showed significantly higher forces for 2.0 mm than 1.5 mm screws, both at 0.1 mm and 0.2 mm deflections and at maximum load. Moreover, no significant differences were reported between titanium and stainless steel miniscrews of equal diameters.

Local anesthesia is performed in dentistry before clinical procedures to avoid pain. Children can show fear at the sight of the needle and pain at its insertion. To make local anesthesia more comfortable, the use of computer-controlled local anesthetic delivery (CCLAD) systems has been developed to control the flow rate of the anesthetic solution injected through the needle. The aim of the present research is to evaluate and compare the discomfort felt by patients using a traditional syringe and the CCLAD system SleeperOne®, by considering pain, size sensation, bitterness, and vomit. 30 patients were included in the study and randomly assigned to traditional anesthesia or CCLAD. After injection, patients were assessed for the abovementioned outcomes. A Visual Analogue Scale (VAS) from 0 to 10 scores was used. As far as pain is concerned, statistically lower mean values were found in the Trial group (p < 0.05). Instead, concerning size, bitterness and vomit perceptions, no statistically significant differences were found between the groups (p > 0.05). Linear regressions were calculated considering technique, quadrant, dental arch, tooth, dentition, sex, and age as independent variables. The technique has shown to have a significant influence on pain (p < 0.05), with lower values for SleeperOne® device. Pain resulted significantly influenced by the type of dentition (p < 0.05), with higher scores for deciduous one. Moreover, perceived pain decreased with the increase of the age of patients (p < 0.05). At last, bitterness perception scores resulted to be higher for primary first molars (p < 0.05). SleeperOne® device seems to be a valid support for the reduction of pain related to anesthetic injection, especially in children. Further studies should evaluate CCLADs' uses combined with lidocaine preanesthetic as well as with conscious sedation through nitrous oxide in order to determine possible synergistic effects between these procedures.

Introduction. Maxillary canine is the most frequent dental element that could likely remain impacted in the bone structure, with a percentage between 1 and 5%. This study presents a case report using a diode laser for surgical-orthodontics disinclusion of a palatal mucosal impacted permanent left upper canine (2.3) and the simultaneous application of an orthodontic bracket. Methods. After cementation of the trans-palatal bar to the upper first molars with a hook for orthodontic traction, local anaesthesia with articaine was performed, followed by surgical operculectomy using a diode laser (810 nm wavelength, continuous wave mode with a power output of 3 W, and a 0.4 mm diameter optical fiber), and the orthodontic bracket with a passive metal looped ligature was applied. Subsequently, active elastic traction was applied on 2.3 and the upper arch was bonded for the application of a series of orthodontic wires, lace-back, and metal ligatures. A progressive reactivation of the elastic traction and extraction of 6.3 was necessary to translate the canine into the correct arch position. Results. Diode laser surgical-orthodontic disinclusion of impacted upper canine was performed successively, resulting in a dry surgical field ideal for orthodontic bracket adhesion. No pain and no swelling have been reported from the patient. The orthodontic treatment allowed the canine to be moved to the correct position in the arch. Conclusions. This case showed that the diode laser is a valid alternative for the surgical-orthodontic disinclusion of an included tooth element.