No abstract

ABSTRACT:In this article we review the biological effects of Al, primarily with respect to the chemical factors controlling Al bioavailability and toxicity, and how its biological effects are best predicted. Our intent is not to duplicate recent reviews on Al chemistry or toxicity, but rather to update the literature since these reviews were published, and to focus on Al speciation and other external chemical influences on Al bioavailability to freshwater biota. Briefly, we first review Al chemistry, with a specific focus on understanding, as well as measuring, Al chemical species of importance to aquatic biota. Next we more comprehensively review Al toxicity and bioavailability to freshwater algae, with a thorough analysis of the relationships between speciation and toxicity, the role of important chemical complexing agents such as P, Si, and organic carbon, as well as the potential for Al to impact algal community structure. A third section reviews the more sparse literature on aquatic higher plants; the fourth section reviews a somewhat more abundant literature of Al toxicity to freshwater invertebrates. We close with an updated review of Al toxicity to fish, again with a focus on mechanisms of toxicity, and the role of Al speciation in controlling bioavailability.

Water pH in the gill micro‐environment of adult fathead minnows (Pimephales promelas Rafinesque) was measured by means of opercular catheters and latex masks. Synthetic soft water of pH <5.7 was rendered more basic as it passed over the gills and water of pH >5.7 was made more acidic, so that pH of the gill micro‐environment stayed at approximately 5.4 to 5.9 over the inspired pH range 4.8 to 6.3. Copper would therefore be >99% Cu2+ at the gills. To measure Cu accumulation on gills, the target organ for Cu toxicity, adult fathead minnows were exposed for 2 to 3 h to 16 μg/L Cu in synthetic soft water (Ca2+ and Na+ approximately 50 μeq/L) at pH 4.8 and 6.3. Gill Cu concentrations were about 1.7 μg Cu/g wet tissue for the inspired pH 4.8 and 6.3 exposures. Added Ca2+ of 2,100 or 4,000 μeq/L reduced gill Cu accumulation during exposures at pH 4.8 but not at pH 6.3. EDTA eliminated Cu deposition at both pH 4.8 and pH 6.3 when equimolar with Cu, but reduced Cu deposition (by 50%) when half equimolar only in the pH 4.8 exposures. These results can be explained by Ca2+ and H+ competition with Cu for gill binding sites and by complexation of Cu by EDTA. Added CaCO3 did not reduce gill Cu, although both competition by Ca2+ and complexation by CO2−3 were expected. Water chemistry calculations suggested that because little CO2−3 is available at pH < 7, CO2−3 from CaCO3 is less likely to affect Cu deposition on fish gills than is Ca2+ from CaCO3.

Although it is well known that increasing water hardness and dissolved organic carbon (DOC) concentrations mitigate the toxicity of aluminum (Al) to freshwater organisms in acidic water (i.e., pH < 6), these effects are less well characterized in natural waters at circumneutral pHs for which most aquatic life regulatory protection criteria apply (i.e., pH 6-8). The evaluation of Al toxicity under varying pH conditions may also be confounded by the presence of Al hydroxides and freshly precipitated Al in newly prepared test solutions. Aging and filtration of test solutions were found to greatly reduce toxicity, suggesting that toxicity from transient forms of Al could be minimized and that precipitated Al hydroxides contribute significantly to Al toxicity under circumneutral conditions, rather than dissolved or monomeric forms. Increasing pH, hardness, and DOC were found to have a protective effect against Al toxicity for fish (Pimephales promelas) and invertebrates (Ceriodaphnia dubia, Daphnia magna). For algae (Pseudokirchneriella subcapitata), the protective effects of increased hardness were only apparent at pH 6, less so at pH 7, and at pH 8, increased hardness appeared to increase the sensitivity of algae to Al. The results support the need for water quality-based aquatic life protection criteria for Al, rather than fixed value criteria, as being a more accurate predictor of Al toxicity in natural waters. Environ Toxicol Chem 2018;37:49-60. C 2017 SETAC

Abstract:The chemistry, bioavailability, and toxicity of aluminum (Al) in the aquatic environment are complex and affected by a wide range of water quality characteristics (including pH, hardness, and dissolved organic carbon). Data gaps in Al ecotoxicology exist for pH ranges representative of natural surface waters (pH 6-8). To address these gaps, a series of chronic toxicity tests were performed at pH 6 with 8 freshwater species, including 2 fish (Pimephales promelas and Danio rerio), an oligochaete (Aeolosoma sp.), a rotifer (Brachionus calyciflorus), a snail (Lymnaea stagnalis), an amphipod (Hyalella azteca), a midge (Chironomus riparius), and an aquatic plant (Lemna minor). The 10% effect concentrations (EC10s) ranged from 98 mg total Al/L for D. rerio to 2175 mg total Al/L for L. minor. From these data and additional published data, species-sensitivity distributions (SSDs) were developed to derive concentrations protective of 95% of tested species (i.e., 50% lower confidence limit of a 5th percentile hazard concentration [HC5-50]). A generic HC5-50 (not adjusted for bioavailability) of 74.4 mg total Al/L was estimated using the SSD. An Al-specific biotic ligand model (BLM) was used to develop SSDs normalized for bioavailability based on site-specific water quality characteristics. Normalized HC5-50s ranged from 93.7 to 534 mg total Al/L for waters representing a range of European ecoregions, whereas a chronic HC5 calculated using US Environmental Protection Agency aquatic life criteria methods (i.e., a continuous criterion concentration [CCC]) was 125 mg total Al/L when normalized to Lake Superior water in the United States. The HC5-50 and CCC values for site-specific waters other than those in the present study can be obtained using the Al BLM. Environ Toxicol Chem 2018;37:36-48. C 2017 SETAC