Early indicators for nanoparticle-derived adverse health effects should provide a relative measure for cytotoxicity of nanomaterials in comparison to existing toxicological data. We have therefore evaluated a human mesothelioma and a rodent fibroblast cell line for in vitro cytotoxicity tests using seven industrially important nanoparticles. Their response in terms of metabolic activity and cell proliferation of cultures exposed to 0-30 ppm nanoparticles (microg g(-1)) was compared to the effects of nontoxic amorphous silica and toxic crocidolite asbestos. Solubility was found to strongly influence the cytotoxic response. The results further revealed a nanoparticle-specific cytotoxic mechanism for uncoated iron oxide and partial detoxification or recovery after treatment with zirconia, ceria, or titania. While in vitro experiments may never replace in vivo studies, the relatively simple cytotoxic tests provide a readily available pre-screening method.

Information, such as text printed on paper or images projected onto microfilm, can survive for over 500 years. However, the storage of digital information for time frames exceeding 50 years is challenging. Here we show that digital information can be stored on DNA and recovered without errors for considerably longer time frames. To allow for the perfect recovery of the information, we encapsulate the DNA in an inorganic matrix, and employ error-correcting codes to correct storage-related errors. Specifically, we translated 83 kB of information to 4991 DNA segments, each 158 nucleotides long, which were encapsulated in silica. Accelerated aging experiments were performed to measure DNA decay kinetics, which show that data can be archived on DNA for millennia under a wide range of conditions. The original information could be recovered error free, even after treating the DNA in silica at 70 8C for one week. This is thermally equivalent to storing information on DNA in central Europe for 2000 years.Prehistorical information put down by our ancestors in cave drawings, texts engraved in gold, and medieval texts are some of the strongest links with our past. An example is the Archimedes Palimpsest that originates from the tenth century. This contains the single known copy of "The Methods of Mechanical Theorems", and represents a cornerstone in the development of geometry and modern calculus. The book has survived more than 1000 years and in 1998 was valued at more than two million USD. In view of this valuation of information it may seem surprising that current efforts of guaranteeing longevity of digital information are scarce (e.g. MDisc, Syylex) and the storage half-life of information has dropped drastically since the transition from analog to digital storage systems.[1]Traditional storage technologies such as optical and magnetic devices are not reliable for long-term (> 50 years) data storage.[2] Furthermore, the development of reliable systems requires long-term testing, which is well above the current device-development timelines. DNA is the only datastorage medium for which real long-term data are available from archeology. Most recently, 300 000 year old mitochondrial DNA from bears and humans has been sequenced. [3] DNA has also previously been utilized as a coding language, for applications in forensics, [4] product tagging, [5] and DNA computing.[6] As a consequence, several approaches to store information on DNA have been proposed. [7] However, those approaches are not reliable as they cannot handle errors efficiently and do not suggest how to (physically) store the DNA to maintain its stability over time.To overcome these issues we combined an error-correcting information-encoding scheme tailored to DNA (Scheme 1) with a previously established chemical method for storing DNA in "synthetic fossils". The corresponding experiments show that only by the combination of the two concepts, could digital information be recovered from DNA stored at the Global Seed Vault (at À18 8C) after over 1 milli...

Quantitative studies on the uptake of nanoparticles into biological systems should consider simultaneous agglomeration, sedimentation, and diffusion at physiologically relevant concentrations to assess the corresponding risks of nanomaterials to human health. In this paper, the transport and uptake of industrially important cerium oxide nanoparticles, into human lung fibroblasts is measured in vitro after exposing thoroughly characterized particle suspensions to a fibroblast cell culture for particles of four separate size fractions and concentrations ranging from 100 ng g(-1) to 100 microg g(-1) of fluid (100 ppb to 100 ppm). The unexpected findings at such low but physiologically relevant concentrations reveal a strong dependence of the amount of incorporated ceria on particle size, while nanoparticle number density or total particle surface area are of minor importance. These findings can be explained on the basis of a purely physical model. The rapid formation of agglomerates in the liquid is strongly favored for small particles due to a high number density while larger ones stay mainly unagglomerated. Diffusion (size fraction 25-50 nm) or sedimentation (size fraction 250-500 nm) limits the transport of nanoparticles to the fibroblast cells. The biological uptake processes on the surface of the cell are faster than the physical transport to the cell at such low concentrations. Comparison of the colloid stability of a series of oxide nanoparticles reveals that untreated oxide suspensions rapidly agglomerate in biological fluids and allows the conclusion thatthe presented transport and uptake kinetics at low concentrations may be extended to other industrially relevant materials.

The chemical and catalytic activity of nanoparticles has strongly contributed to the current tremendous interest in engineered nanomaterials and often serves as a guiding principle for the design of functional materials. Since it has most recently become evident that such active materials can enter into cells or organisms, the present study investigates the level of intracellular oxidations after exposure to iron-, cobalt-, manganese-, and titania-containing silica nanoparticles and the corresponding pure oxides in vitro. The resulting oxidative stress was quantitatively measured as the release of reactive oxygen species (ROS). The use of thoroughly characterized nanoparticles of the same morphology, comparable size, shape, and degree of agglomeration allowed separation of physical (rate of particle uptake, agglomeration, sedimentation) and chemical effects (oxidations). Three sets of control experiments elucidated the role of nanoparticles as carriers for heavy metal uptake and excluded a potential interference of the biological assay with the nanomaterial. The present results indicate that the particles could efficiently enter the cells by a Trojan-horse type mechanism which provoked an up to eight times higher oxidative stress in the case of cobalt or manganese if compared to reference cultures exposed to aqueous solutions of the same metals. A systematic investigation on iron-containing nanoparticles as used in industrial fine chemical synthesis demonstrated that the presence of catalytic activity could strongly alter the damaging action of a nanomaterial. This indicates that a proactive development of nanomaterials and their risk assessment should consider chemical and catalytic properties of nanomaterials beyond a mere focus on physical properties such as size, shape, and degree of agglomeration.

Synthesis in a day! Carbon‐coated metal nanoparticles can be covalently functionalized by diazonium chemistry. These colloidal reagents can now serve as a basis to magnetically functionalize molecules during synthesis, enabling their recovery within seconds.

No abstract

Copper nanoparticles with a mean carbon coating of about 1 nm were continuously produced at up to 10 g h(-1) using a modified flame spray synthesis unit under highly reducing conditions. Raman spectroscopy and solid state (13)C magic angle spinning nuclear magnetic resonance spectroscopy revealed that the thin carbon layer consisted of a sp(2)-hybridized carbon modification in the form of graphene stacks. The carbon layer protected the copper nanoparticles from oxidation in air. Bulk pills of pressed carbon/copper nanoparticles displayed a highly pressure- and temperature-dependent electrical conductivity with sensitivity at least comparable to commercial materials. These properties suggest the use of thin carbon/copper nanocomposites as novel, low-cost sensor materials and offer a metal-based alternative to the currently used brittle oxidic spinels or perovskites.

This protocol describes a method for encapsulating DNA into amorphous silica (glass) spheres, mimicking the protection of nucleic acids within ancient fossils. In this approach, DNA encapsulation is achieved after the ammonium functionalization of silica nanoparticles. Within the glass spheres, the nucleic acid molecules are hermetically sealed and protected from chemical attack, thereby withstanding high temperatures and aggressive radical oxygen species (ROS). The encapsulates can be used as inert taggants to trace chemical and biological entities. The present protocol is applicable to short double-stranded (ds) and single-stranded (ss) DNA fragments, genomic DNA and plasmids. The nucleic acids can be recovered from the glass spheres without harm by using fluoride-containing buffered oxide etch solutions. Special emphasis is placed in this protocol on the safe handling of these buffered hydrogen fluoride solutions. After dissolution of the spheres and subsequent purification, the nucleic acids can be analyzed by standard techniques (gel electrophoresis, quantitative PCR (qPCR) and sequencing). The protocol requires 6 d for completion with a total hands-on time of 4 h.