New particle formation in the Arctic atmosphere is an important source of aerosol particles. Understanding the processes of Arctic secondary aerosol formation is crucial due to their significant impact on cloud properties and therefore Arctic amplification. We observed the molecular formation of new particles from low‐volatility vapors at two Arctic sites with differing surroundings. In Svalbard, sulfuric acid (SA) and methane sulfonic acid (MSA) contribute to the formation of secondary aerosol and to some extent to cloud condensation nuclei (CCN). This occurs via ion‐induced nucleation of SA and NH3 and subsequent growth by mainly SA and MSA condensation during springtime and highly oxygenated organic molecules during summertime. By contrast, in an ice‐covered region around Villum, we observed new particle formation driven by iodic acid but its concentration was insufficient to grow nucleated particles to CCN sizes. Our results provide new insight about sources and precursors of Arctic secondary aerosol particles.

Atmospheric new particle formation (NPF) and growth significantly influences the indirect aerosol-cloud effect within the polar climate system. In this work, the aerosol population is categorised via cluster analysis of aerosol number size distributions (9–915 nm, 65 bins) taken at Villum Research Station, Station Nord (VRS) in North Greenland during a 7 year record (2010–2016). Data are clustered at daily averaged resolution; in total, we classified six categories, five of which clearly describe the ultrafine aerosol population, one of which is linked to nucleation events (up to 39% during summer). Air mass trajectory analyses tie these frequent nucleation events to biogenic precursors released by open water and melting sea ice regions. NPF events in the studied regions seem not to be related to bird colonies from coastal zones. Our results show a negative correlation (r = −0.89) between NPF events and sea ice extent, suggesting the impact of ultrafine Arctic aerosols is likely to increase in the future, given the likely increased sea ice melting. Understanding the composition and the sources of Arctic aerosols requires further integrated studies with joint multi-component ocean-atmosphere observation and modelling.

The radiative balance in the Arctic region is sensitive to in-cloud processes, which principally depend on atmospheric aerosols, including ice nucleating particles (INPs). High temperature INPs (active at ≥−15 °C) are common in the Arctic. While laboratory and limited in situ studies show that the high-temperature active INPs are associated with bioaerosols and biogenic compounds, there is still little quantitative insight into the Arctic biogenic INPs and bioaerosols. We measured concentrations of bioaerosols, bacteria, and biogenic INPs at the Villum Research Station (VRS, Station Nord) in a large number of snow (15) and air (51) samples. We found that INPs active at high subzero temperatures were present both in spring and summer. Air INP concentrations were higher in summer (18 INP m −3 at ≥−10 °C) than in spring (<4 INP m −3 at ≥−10 °C), when abundant INPs were found in snowfall (1.4 INP mL −1 at ≥−10 °C). Also, in summer, a significantly higher number of microbial and bacterial cells were present compared to the spring. A large proportion (60%−100%) of INPs that were active between −6 °C and −20 °C could be deactivated by heating to 100 °C, which was indicative of their predominantly proteinaceous origin. In addition, there was a significant linear regression between the summer air concentrations of INPs active at ≥−10 °C and air concentrations of bacterial-marker-genes (p < 0.0001, R 2 = 0.999, n = 6), pointing at bacterial cells as the source of high-temperature active INPs. In conclusion, the majority of INPs was of proteinaceous, and possibly of bacterial, origin and was found in air during summer and in snowfall during springtime.

Radioisotope power systems have demonstrated numerous advantages over other types of power supplies for long-lived, unattended applications in space and in remote terrestrial locations. Many especially challenging power applications can be satisfied by proper selection, design, and integration of the radioisotope heat source and the power conversion technologies that are now available or that can be developed. This paper provides a brief review of the factors influencing selection of radioisotopes and design of power systems, and discusses the current state of practice and future programmatic and technical challenges to continued use of radioisotope power systems in space.

 Accumulation mode aerosol is measured in North East Greenland during a 7 year record, apportioning 56% of total aerosol size distributions.  Three aerosol categories are found: accumulation Haze (32%), accumulation Aged (14%) and accumulation Bimodal (6%).  Accumulation categories have very distinct chemical and physical properties across different seasons.  Arctic accumulation mode aerosols during summer coexist with a smaller Aitken mode, likely biogenic.  Cloud Condensation Nuclei (CCN) measurements suggest that ultrafine aerosol (~30-60nm) drives CCN concentrations in the Arctic during summer.