No abstract

Perovskite solar cells (PeSCs) have been considered one of the competitive next generation power sources. To date, light-to-electric conversion efficiencies have rapidly increased to over 10%, and further improvements are expected. However, the poor device reproducibility of PeSCs ascribed to their inhomogeneously covered film morphology has hindered their practical application. Here, we demonstrate high-performance PeSCs with superior reproducibility by introducing small amounts of N-cyclohexyl-2-pyrrolidone (CHP) as a morphology controller into N,N-dimethylformamide (DMF). As a result, highly homogeneous film morphology, similar to that achieved by vacuum-deposition methods, as well as a high PCE of 10% and an extremely small performance deviation within 0.14% were achieved. This study represents a method for realizing efficient and reproducible planar heterojunction (PHJ) PeSCs through morphology control, taking a major step forward in the low-cost and rapid production of PeSCs by solving one of the biggest problems of PHJ perovskite photovoltaic technology through a facile method.

In this work, we synthesized water-soluble polyfluorene derivatives (WPFs) with anionic and/or cationic side chains, which were used as an indium tin oxide (ITO) cathode interfacial layer in inverted polymer solar cells. Three WPFs (WPFN+, WPFZW, and WPFS-) were obtained via Suzuki coupling reactions. Their solubility in polar solvents allowed the WPFs to be used as interfacial layers in inverted polymer solar cells (I-PSCs). Among the WPF-modified ITO electrodes, WPFN+ (with ammonium side chains)-modified ITO can be used as a cathode for electron extraction, while WPFS- (with sulfonate side chains)-modified ITO cannot extract electrons in I-PSCs based on poly(3-hexylthiophene): [6,6]-phenyl-C61-butyric acid methyl ester (P3HT:PC61BM). The electron extraction of WPF-modified ITO can mainly be attributed to the different dipole formations at the WPF/ITO interfaces, based on the types of ionic groups on the side chains of the polyfluorene. In addition, we observed that the extent of ITO work-function modification was not always exactly correlated with the device performance based on the results obtained using a WPFZW (with ammonium and sulfonate side chains)-modified ITO electrode.

Organometallic halide perovskite-based solar cells have exhibited rapidly increasing efficiencies through the use of mesoporous composites. The addition of materials used in organic solar cells to perovskite-based solar cells (PSCs) enables the fabrication of low-cost, flexible, low-temperature, solutionprocessed PSCs. However, obtaining sufficient coverage of the organic layer, usually poly(3,4-ethylenedioxythiophene)−poly(styrenesulfonate) (PEDOT:PSS), with CH 3 NH 3 PbI 3−x Cl x films remains difficult in spite of the advances. In this study, we investigated the influence of controlling the solvent evaporation rate on the degree of PEDOT:PSS surface coverage by CH 3 NH 3 PbI 3−x Cl x . We determined that an adequately fast spinning speed, drying at room temperature, and stepwise ramp annealing are critical for obtaining optimized planar hybrid perovskite solar cells with an ITO/PEDOT:PSS/CH 3 NH 3 PbI 3−x Cl x /PCBM/Al structure and efficiencies of up to 11.8%.

No abstract