OBJECTIVE To describe clinical use of a locking compression plate (LCP) for proximal interphalangeal joint (PIPJ) arthrodesis in horses and compare outcomes for horses that underwent the procedure as treatment for fracture of the middle phalanx (P2) versus other causes. DESIGN Retrospective case series. ANIMALS 29 client-owned horses. PROCEDURES Medical records of 2 veterinary teaching hospitals from 2008 through 2014 were reviewed to identify horses that underwent PIPJ arthrodesis of 1 limb. Signalment, surgical, and outcome-related variables were recorded. Owners were contacted from 1 to 6 years after surgery to determine rehabilitation time, current use of the horse, and overall owner satisfaction with the procedure. Success was determined on the basis of owner satisfaction and outcome for intended use. Variables of interest were compared statistically between horses that underwent surgery for P2 fracture versus other reasons. RESULTS 14 horses underwent surgery for treatment of P2 fracture, and 15 had surgery because of osteoarthritis, subluxation, or osteochondrosis. Median convalescent time after surgery (with no riding or unrestricted exercise) was 7 months. Four horses were euthanized; of 23 known alive at follow-up, 22 were not lame, and 18 had returned to their intended use (8 and 10 at higher and lower owner-reported levels of work, respectively). Horses undergoing arthrodesis for reasons other than fracture were significantly more likely to return to their previous level of work. Twenty-two of 24 owners contacted indicated satisfaction with the procedure. CONCLUSIONS AND CLINICAL RELEVANCE Surgical arthrodesis of the PIPJ was successful in most horses of the study population. Various nuances of the system for fracture repair need to be understood prior to its use.

Adequate fixation at the time of cementless stem implantation depends on the operator's experience. An objective evaluation method to determine whether the stem has been appropriately implanted may be helpful. We studied the relationship between the hammering sound frequency during stem implantation and internal stress in a femoral model, and evaluated the possible usefulness of hammering sound frequency analysis for preventing intraoperative fracture. Three types of cementless stem (BiCONTACT®, SL-PLUS®, and AI-Hip®) were used. Surgeons performed stem insertion using a procedure similar to that employed in a routine operation. Stress was estimated by finite element analysis, the hammering force was measured, and frequency analysis of hammering sound data obtained using a microphone. Finite element analysis showed a decrease in the hammering sound frequency with an increase in the estimated maximum stress. When a decrease in frequency was observed, adequate hammering had occurred, and the continuation of hammering risked fracture. Based on the relationship between stress and frequency, the evaluation of changes in frequency may be useful for preventing the development of intraoperative fractures. Using our method, when a decrease in frequency is observed, the hammering force should be reduced. Hammering sound frequency analysis may allow the prediction of bone fractures that can be visually confirmed, and may be a useful objective evaluation method for the prevention of intraoperative periprosthetic fractures during stem insertion.

During cementless stem fixation, impaction of the stem is occasionally complicated by bony injuries. Small fractures not visible to the eye during surgery or on post-operative radiographs may remain undetected, and the incidence of such injuries may be underestimated. Employing the same techniques as those employed during total hip arthroplasty, we implanted cementless stems into artificial femora, with equivalent mechanical characteristics to living femora. The hammering force applied to the femur and the displacement of the stem and femur were measured using a load sensor and imaging, respectively. The von Mises stress generated in the femur during cementless stem press-fixation was also measured using finite element analysis. Average hammering force under these conditions (9.25 kN) was sufficient to cause damage to the artificial femur. The first two of eight hammer strikes caused most displacement of the stem. The von Mises stresses generated by the first and second hammer strikes were 31 and 68 MPa, respectively. Applying a high average hammering force to the stem after displacement has ceased probably contributes to the generation of intraoperative fractures during cementless stem fixation. Given that two strikes appeared to be sufficient, we believe that hammering force should be reduced to a micro-adjustment level after the second hit.

Abstract:The incidence of spontaneous osteoarthritis (OA) in female STR/Ort mice is much lower than that observed in male STR/Ort mice; however, the reason for the differential incidence of OA between sexes has not been elucidated. Here, we investigated and compared age-and sex-related bone mineral density and architectural changes in male and female STR/ Ort mice. Bone architecture and bone mineral density (BMD) of femurs were examined in 5-, 10-, 15-, 20-, and 35-week-old male and female STR/Ort mice by microscopic computed tomography (µCT). Angular degrees of internal tibial torsion (ADITT) were also measured in mice at 5, 15, and 35 weeks of age. Earlier decreases of cancellous volume and BMD were found in male STR/Ort mice. Using µCT, an age-related decline of bone marrow space in femoral diaphysis was observed in both males and females but was more dramatic in females. In addition, an earlier increase of ADITT was observed in male STR/Ort mice, suggesting that internal rotation of the tibia may contribute to OA. Age-and sex-related bone architectural changes clearly differ between male and female STR/Ort mice. These differences in bone structure, particularly ADITT, may explain the differential incidence of OA in STR/Ort mice.

Antibiotic-impregnated hip cement spacers of various types and materials have been used in the treatment of periprosthetic hip infections. We developed a handmade spacer by using polymethylmethacrylate (PMMA) and/or α-tricalcium phosphate (α-TCP). In this study, we retrospectively reviewed the surgical outcomes in 36 consecutive patients treated with 2-stage revision total hip arthroplasty by using our antibiotic-impregnated hip cement spacers. We aimed to analyze the infection control and reinfection rates after revision surgery. Moreover, we analyzed the possible predictors of postoperative reinfection. After exclusion of 1 patient who died immediately after the first-stage surgery, infection was controlled in 33 of the 36 hips (success rate, 91.7%). Two of these 33 hips underwent resection arthroplasty. Of the 36 hips that had been treated with the antibiotic-cement spacer, 31 hips (86.1%) were eligible for the second-stage prosthesis re-implantation. The 31 protocol hip joints of patients followed up for >6 months (mean, 48.6 months). Ten of these 31 hips (32.3%) became reinfected. No possible predictor examined differed significantly between the reinfection-positive and reinfection-negative groups. However, spacers consisting of PMMA cement alone were associated with the highest risk of reinfection. Therefore, α-TCP-containing antibiotic-impregnated hip cement spacers might decrease the reinfection rate in patients undergoing re-implantation.