The use of sensors for detection, measurement and evaluation of mechanical and thermal loads is well known and essential for the implementation of »Structural Health Monitoring« (SHM). For this, sensors are mainly used for condition monitoring of mechanical loads and their impact to the castings state, which is a decisive advantage for safety-related components. The use of sensors on the surface of metallic components, in particular of cast metal components made of aluminum, is still limited to the use of strain gauges. They are usually applied on the surface of the cast metal components and get fixed by adhesives. The idea is, to integrate the sensors directly during the aluminum casting process. Since integrated sensors are naturally protected against chemical and mechanical influences, furthermore the load can be measured directly at the point of interest inside the component. Measurement data can be recorded and provide a good data basis for future calculations and dimensioning of components, which is known as »Data Mining« or »Industrial Data Space«. New technology and material combinations, which allow the fabrication of sensors capable of withstanding force and temperature during the integration process in aluminum casting, are investigated.In this paper, the design and fabrication of a strain gauge printed on an aluminum sheet is shown. These sensor sheets get integrated in aluminum during high pressure die casting (HPDC) in a way that a specimen is build up. The specimen is characterized in a fatigue bending test and the sensor data was read permanently during this test. It is shown that the new approach with printed thick film sensors on aluminum substrate sheets works properly to withstand the heavy thermal conditions during high pressure die casting. The fabricated sensor is able to sense the mechanical tiredness and detects the fatigue of the metal matrix. This a first step to use such material integrated sensors in structural health monitoring applications.
There is currently a large demand for aluminum components to measure the mechanical and thermal loads to which they are subjected. With structural health monitoring, components in planes, vehicles, or bridges can monitor critical loads and potentially prevent an impending fatigue failure. Externally attached sensors need a structural model to obtain knowledge of the mechanical load at the point of interest, whereas embedded sensors can be used for direct measurement at the point of interest. To produce an embedded sensor, which is automatically encapsulated against environmental influence, the sensor must be able to withstand the boundary conditions of the host component’s manufacturing process. This embedding process is particularly demanding in the case of casting. Previous work showed that silicon-based sensors have a high failure rate when embedded in cast aluminum parts and that using aluminum as a substrate is preferable under these circumstances. In the present paper, we present the fabrication process for the combination of a thick-film insulation and a thin-film strain gauge sensor, on such an aluminum substrate. The sensor is capable of withstanding high temperatures of at least 600 °C for over 20 min and a subsequent embedding in a gravity die casting process.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.