Based on protein folding considerations, a pentapeptide ligand, CALNN, which converts citrate-stabilized gold nanoparticles into extremely stable, water-soluble gold nanoparticles with some chemical properties analogous to those of proteins, has been designed. These peptide-capped gold nanoparticles can be freeze-dried and stored as powders that can be subsequently redissolved to yield stable aqueous dispersions. Filtration, size-exclusion chromatography, ion-exchange chromatography, electrophoresis, and centrifugation can be applied to these particles. The effect of 58 different peptide sequences on the electrolyte-induced aggregation of the nanoparticles was studied. The stabilities conferred by these peptide ligands depended on their length, hydrophobicity, and charge and in some cases resulted in further improved stability compared with CALNN, yielding detailed design criteria for peptide capping ligands. A simple strategy for the introduction of recognition groups is proposed and demonstrated with biotin and Strep-tag II.

A technique to measure the electrical conductivity of single molecules has been demonstrated. The method is based on trapping molecules between an STM tip and a substrate. The spontaneous attachment and detachment of a,o-alkanedithiol molecular wires was easily monitored in the time domain. Electrical contact between the target molecule and the gold probes was achieved by the use of thiol groups present at each end of the molecule. Characteristic jumps in the tunnelling current were observed when the tip was positioned at a constant height and the STM feedback loop was disabled. Histograms of the measured current jump values were used to calculate the molecular conductivity as a function of bias and chain length. In addition, it is demonstrated that these measurements can be carried out in a variety of environments, including aqueous electrolytes. The changes in conductivity with chain length obtained are in agreement with previous results obtained using a conducting AFM and the origin of some discrepancies in the literature is analysed.

Spontaneous formation of stable molecular wires between a gold scanning tunneling microscopy (STM) tip and substrate is observed when the sample has a low coverage of alpha,omega-dithiol molecules and the tunneling resistance is made sufficiently small. Current-distance curves taken under these conditions exhibit characteristic current plateaux at large tip-substrate separations from which the conductivity of a single molecule can be obtained. The versatility of this technique is demonstrated using redox-active molecules under potential control, where substantial reversible conductivity changes from 0.5 to 2.8 nS were observed when the molecule was electrochemically switched from the oxidized to the reduced state.

Short chains of porphyrin molecules can mediate electron transport over distances as long as 5-10 nm with low attenuation. This means that porphyrin-based molecular wires could be useful in nanoelectronic and photovoltaic devices, but the mechanisms responsible for charge transport in single oligo-porphyrin wires have not yet been established. Here, based on electrical measurements of single-molecule junctions, we show that the conductance of the oligo-porphyrin wires has a strong dependence on temperature, and a weak dependence on the length of the wire. Although it is widely accepted that such behaviour is a signature of a thermally assisted incoherent (hopping) mechanism, density functional theory calculations and an accompanying analytical model strongly suggest that the observed temperature and length dependence is consistent with phase-coherent tunnelling through the whole molecular junction.

There is much discussion of molecules as components for future electronic devices. However, the contacts, the local environment and the temperature can all affect their electrical properties. This sensitivity, particularly at the single-molecule level, may limit the use of molecules as active electrical components, and therefore it is important to design and evaluate molecular junctions with a robust and stable electrical response over a wide range of junction configurations and temperatures. Here we report an approach to monitor the electrical properties of single-molecule junctions, which involves precise control of the contact spacing and tilt angle of the molecule. Comparison with ab initio transport calculations shows that the tilt-angle dependence of the electrical conductance is a sensitive spectroscopic probe, providing information about the position of the Fermi energy. It is also shown that the electrical properties of flexible molecules are dependent on temperature, whereas those of molecules designed for their rigidity are not.