No abstract

A comprehensive lignin structure analysis of ten industrially relevant hardwood species is presented. Milled wood lignin (MWL) was isolated from each species using a modified protocol and all milled wood lignin preparations were analyzed through quantitative (13)C NMR spectroscopy, elemental analysis, methoxyl analysis, sugar analysis, and nitrobenzene oxidation. Nitrobenzene oxidation and ozonation were carried out on extractive-free wood, alkali-extracted wood, milled wood lignin, and alkali-extracted lignin. Milled wood lignin isolated by the modified protocol was found to be representative of the total lignin in alkali-extracted wood. Significant variations in lignin structures, such as syringylpropane/guaiacylpropane ratio (S/G ratio), arylglycerol-β-aryl ether (β-O-4), degree of condensation, and elemental and methoxyl contents, were found among the hardwood species studied. These structural variations among species appear to be correlated to a single factor, the syringyl/guaiacyl ratio. A new method to predict the S/G ratio of total lignin in wood was developed, using a calibration line established by the syringaldehyde/vanillin (S/V) ratio (nitrobenzene oxidation) and the S/G ratio ((13)C NMR) of milled wood lignin (MWL).

Milled wood lignins from alkaline pretreated wood with very low sugar content and a wide range of syringyl-to-guaiacyl (S/G) ratio between 1.2 and 3.0 were isolated from 12 industrially valuable hardwood (HW) species. The lignin preparations were investigated by means of a comprehensive 13C nuclear magnetic resonance (NMR) methodology to address the possibilities and limitations of this approach for HW native lignins and to estimate the structural variations within HW lignins. Good correlations were found for different independent methods for the quantification of major lignin moieties. The results were reliable at the C6 level and not only for relative comparison. The correlation was good between methoxyl group determinations by wet chemistry and those by 13C NMR spectroscopy. The limitations of the 13C NMR method were also pointed out. The differences in the S/G ratios can be large, but other structural deviations are less significant. Strong correlations between the S/G ratios and the amounts of other structural peculiarities could not be found by the 13C NMR approach. However, with increasing S/G ratios, the β-O-4 content showed increasing tendencies and the degree of condensation showed decreasing tendencies.

No abstract

aMost studies aimed at determining rates of hardwood delignification and carbohydrate degradation have focused on understanding the behavior of a single wood species. Such studies tend to determine either the delignification rate or the rate of carbohydrate degradation without examining the potential interactions resulting from related variables. The current study provides a comprehensive evaluation on both lignin and carbohydrate degradation during kraft pulping of multiple hardwood species. The kraft delignification rates of E. urograndis, E. nitens, E. globulus, sweet gum, maple, red oak, red alder, cottonwood, and acacia were obtained. Furthermore, the kinetics of glucan, xylan, and total carbohydrate dissolution during the bulk phase of the kraft pulping process for the above species were also investigated. The wide ranges of delignification and carbohydrate degradation rates were correlated to wood chemical characteristics. It appears that the S/G ratio and lignincarbohydrate-complexes (LCCs) are the main characteristics responsible for the differences in kraft pulping performance among the hardwoods studied.