No abstract

In this study, several series of experiments on turning process of AISI 12L14 free cutting steel characterized by its self-lubrication and the high percentage of lead in its composition were performed to rate the influence of cutting conditions (Vc, f and ap) on the machining performance such as surface roughness, cutting force, cutting power and material removal rate. A computer generated optimal design of experiment based on the I-optimality criteria along with analysis of variance was created to study the characterizations in turning of this steel, and desirability function was utilized for the optimization. The global optimization, combined high surface quality and productivity with low cutting power consumption, gave 12 optimal setting points provided high desirability values. The obtained correlation for surface roughness, cutting force, material removal rate and cutting power were 99.4%, 95.5%, 99.7% and 94.3%, respectively.

No abstract

No abstract

The present research work proposes an experimental investigation helping to comprehend fundamental impacts of operating conditions during the cutting of cobalt alloys (Stellite 6). Thus, an experimental design was adopted to allow to build predicted mathematical models for the outputs, which are the average peak-to-valley profile roughness (Rz) and the tangential cutting force (Ft). Artificial neural network (ANN), support vector machine (SVM) and response surface methodology (RSM) were exploited to model the pre-cited outputs according to operation parameters. As a result, it has been highlighted that both feed rate and cutting depth, considerably, affect tangential cutting force evolution. Moreover, results show that both the insert feed rate and nose radius, are higher. This means the average peak-to-valley profile roughness is higher. In order to put out the effect of operating parameters on cutting outputs, Analysis of variance (ANOVA) method has been employed. This has allowed the detection of significant cutting conditions affecting average peak-to-valley profile roughness and tangential cutting force. In fact, to highlight the performance of adopted mathematical approaches, a comparison between RSM, ANN, and SVM has been also established in this study.