No abstract

The effects of bimodal grain size distributions on the mechanical properties of a newly developed TRansformation-TWinning induced plasticity (TRIP/TWIP) steel were investigated. The microstructures with different levels of bimodal grain size distributions were achieved through rolling at 1000, 1100 and 1200 °C where the restoration processes (in particular recrystallization) could be occurred at different rates. The results indicated that the bimodal distribution parameter was increased by raising the rolling temperature and lowering the thickness reduction. In addition, the room temperature strength and ductility were higher for the materials rolled at higher temperatures, where the level of bimodal grain size distributions (bimodality) was greater. This was justified considering the higher possibility of strain induced transformation and twinning in coarser grains than that of finer ones; this in fact would dictate the material work hardening potential during subsequent tensile deformation. For the material rolled at 1000 °C, where the grain size distributions were more homogeneous and the level of bimodal distributions was low, the austenite to martensite transformation during tensile deformation at room temperature was the prevailing mechanism to induce the plasticity. In contrast, in the materials rolled at 1100 and 1200 °C the mechanical twinning came into action thereby a rapid hardening region was recognized in their work hardening behavior. These effects were correlated to the length of work hardening region (dictated by twinning), and the magnitude of hardening rate (controlled by transformation of austenite to a' martensite).Peer ReviewedPostprint (author's final draft

No abstract

No abstract

No abstract

No abstract

No abstract

Yttria stabilized zirconia thick coatings were thermally sprayed from two different feedstock powders. Coating characteristics such as density, crystalline phase composition, and microstructure were evaluated. The thermal expansion coefficient and thermal diffusivity were measured as a function of temperature up to 800°C and analyzed in terms of the microstructural features. The ability of available models to relate the measured thermal properties to the microstructural features as characterized by readily available methods was assessed. The importance of pore shape and orientation on the thermal conductivity was evidenced. The thermal contact resistance between the substrate and the coating in these samples was estimated from the thermal diffusivity data, and found to change during cooling from 800°C.