Luminescence dating is used extensively to provide absolute chronologies for Late Pleistocene sediments. Nowadays, most optical dates are based on quartz optically stimulated luminescence (OSL). However, the application of this signal is usually limited to the last ∼100 ka because of saturation of the quartz luminescence signal with dose. In contrast, the feldspar infrared stimulated luminescence (IRSL) dose–response curve grows to much higher doses; this has the potential to extend the datable age range by a factor of 4–5 compared with quartz OSL. However, it has been known for several decades that this IRSL signal is unstable, and this instability often gives rise to significant age underestimation. Here we test against independent age control the recently developed feldspar post‐IR IRSL approach to the dating of sediments, which appears to avoid signal instability. A physical model explaining our observations is discussed, and the method is shown to be accurate back to 600 ka. The post‐IR IRSL signal is reduced by exposure to daylight more slowly than that from quartz and low‐temperature IRSL, preventing its general application to young (e.g. Holocene) sediments. Nevertheless, this new approach is widely applicable (feldspar of appropriate luminescence behaviour is even more ubiquitous than quartz). These characteristics make this a method of great importance for the dating of Middle and Late Pleistocene deposits.
There are many examples of buried rock surfaces whose age is of interest to geologists and archaeologists. Luminescence dating is a potential method which can be applied to dating such surfaces; as part of a research project which aims to develop such an approach, the degree of resetting of OSL signals in grains and slices from five different cobbles/boulders collected from a modern beach is investigated. All the rock surfaces are presumed to have been exposed to daylight for a prolonged period of time (weeks to years). Feldspar was identified as the preferred dosimeter because quartz extracts were insensitive. Dose recovery tests using solar simulator and IR diodes on both K-feldspar grains and solid slices taken from the inner parts of the rocks are discussed. Preheat plateau results using surface grains and slices show that significant thermal transfer in naturally bleached samples can be avoided by keeping preheat temperatures low. Equivalent doses from surface K-feldspar grains were highly scattered and much larger than expected (0.02 Gy to >100 Gy), while solid surface slices gave more reproducible small doses (mean = 0.17±0.02 Gy, n = 32). Neither crushing nor partial bleaching were found to be responsible for the large scattered doses from grains, nor did the inevitable contribution from Na-feldspar to the signal from solid slices explain the improved reproducibility in the slices. By modelling the increase of luminescence signal with distance into the rock surface, attenuation factors were derived for two samples. These indicate that, for instance, bleaching at a depth of 2 mm into these samples occurs at about ~28% of the rate at the surface. We conclude that it should be possible to derive meaningful burial doses of >1 Gy from such cobbles; younger samples would probably require a correction for incomplete bleaching.
[1] We pioneer a technique of surface-exposure dating based upon the characteristic form of an optically stimulated luminescence (OSL) bleaching profile beneath a rock surface; this evolves as a function of depth and time. As a field illustration of this new method, the maximum age of a premier example of Barrier Canyon Style (BCS) rock art in Canyonlands National Park, Utah, USA, is constrained. The natural OSL signal from quartz grains is measured from the surface to a depth of >10 mm in three different rock samples of the Jurassic Navajo Sandstone. Two samples are from talus with unknown daylight exposure histories; one of these samples was exposed at the time of sampling and one was buried and no longer light exposed. A third sample is known to have been first exposed 80 years ago and was still exposed at the time of sampling. First, the OSL-depth profile of the known-age sample is modeled to estimate material-dependent and environmental parameters. These parameters are then used to fit the model to the corresponding data for the samples of unknown exposure history. From these fits we calculate that the buried sample was light exposed for $700 years before burial and that the unburied sample has been exposed for $120 years. The shielded surface of the buried talus sample is decorated with rock art; this rock fell from the adjacent Great Gallery panel. Related research using conventional OSL dating suggests that this rockfall event occurred $900 years ago, and so we deduce that the rock art must have been created between $1600 and 900 years ago. Our results are the first credible estimates of exposure ages based on luminescence bleaching profiles. The strength of this novel OSL method is its ability to establish both ongoing and prior exposure times, at decadal to millennial timescales or perhaps longer (depending on the environmental dose rate) even for material subsequently buried. This has considerable potential in many archeological, geological and geo-hazard applications.Citation: Sohbati, R., A. S. Murray, M. S. Chapot, M. Jain, and J. Pederson (2012), Optically stimulated luminescence (OSL) as a chronometer for surface exposure dating,
The measurement of erosion and weathering rates in different geomorphic settings and over diverse temporal and spatial scales is fundamental to the quantification of rates and patterns of earth surface processes. A knowledge of the rates of these surface processes helps one to decipher their relative contribution to landscape evolutioninformation that is crucial to understanding the interaction between climate, tectonics and landscape. Consequently, a wide range of techniques has been *Manuscript Click here to view linked References 2 developed to determine short-(<10 2 a) and long-term (> 4 a) erosion rates. However, no method is available to quantify hard rock erosion rates at centennial to millennial timescales. Here we propose a novel technique, based on the solar bleaching of luminescence signals with depth into rock surfaces, to bridge this analytical gap. We apply our technique to glacial and landslide boulders in the Eastern Pamirs, China. The calculated erosion rates from the smooth varnished surfaces of 7 out of the 8 boulders sampled in this study vary between < 0.038±0.002 and 1.72±0.04 mm ka-1 (the eighth boulder gave an anomalously high erosion rate, possibly due to a recent chipping/cracking loss of surface). Given this preferential sampling of smooth surfaces, assumed to arise from grain-by-grain surface loss, we consider these rates as minimum estimates of rock surface denudation rates in the Eastern Pamirs, China.
Most catastrophic earthquakes occur along fast-moving faults, although some of them are triggered by slow-moving ones. Long paleoseismic histories are infrequent in the latter faults. Here, an exceptionally long paleoseismic record (more than 300 k.y.) of a slow-moving structure is presented for the southern tip of the Alhama de Murcia fault (Eastern Betic shear zone), which is characterized by morphological expression of current tectonic activity and by a lack of historical seismicity. At its tip, the fault divides into a splay with two main faults bounding the Góñar fault system. At this area, the condensed sedimentation and the distribution of the deformation in several structures provided us with more opportunities to obtain a complete paleoseismic record than at other segments of the fault. The tectonic deformation of the system was studied by an integrated structural, geomorphological, and paleoseismological approach. Stratigraphic and tectonic features at six paleoseismic trenches indicate that old alluvial units have been repeatedly folded and thrusted over younger ones along the different traces of the structure. The correlation of the event timing inferred for each of these trenches and the application of an improved protocol for the infrared stimulated luminescence (IRSL) dating of K-feldspar allowed us to constrain a paleoseismic record as old as 325 ka. We identifi ed a minimum of six possible paleoearthquakes of M w = 6-7 and a maximum mean recurrence interval of 29 k.y. This provides compelling evidence for the underestimation of the seismic hazard in the region.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.