Supported catalysts are among the most important classes of catalysts.T hey are typically prepared by wetchemical methods,s uch as impregnation or co-precipitation. Here we disclose that dry ball milling of macroscopic metal powder in the presence of asupport oxide leads in many cases to supported catalysts with particles in the nanometer size range.V arious supports,i ncluding TiO 2 ,A l 2 O 3 ,F e 2 O 3 ,a nd Co 3 O 4 ,a nd different metals,s uch as Au,P t, Ag,C u, and Ni, were studied, and for eacho ft he supports and the metals, highly dispersed nanoparticles on supports could be prepared. The supported catalysts were tested in CO oxidation, where they showed activities in the same range as conventionally prepared catalysts.T he method thus provides as imple and cost-effective alternative to the conventionally used impregnation methods.

In situ ball milling of solid catalysts is a promising yet almost unexplored concept for boosting catalytic performance. The continuous preferential oxidation of CO (CO-PROX) under in situ ball milling of Cu-based catalysts such as Cu/Cr O is presented. At temperatures as low as -40 °C, considerable activity and more than 95 % selectivity were achieved. A negative apparent activation energy was observed, which is attributed to the mechanically induced generation and subsequent thermal healing of short-lived surface defects. In situ ball milling at sub-zero temperatures resulted in an increase of the CO oxidation rate by roughly 4 orders of magnitude. This drastic and highly selective enhancement of CO oxidation showcases the potential of in situ ball milling in heterogeneous catalysis.

The cleavage of the N2 triple bond on the Fe(111) surface is believed to be the rate limiting step of the famed Haber-Bosch ammonia catalysis. Using a combination of machine learning potentials and advanced simulation techniques, we study this important catalytic step as a function of temperature. We find that at low temperatures our results agree with the well-established picture. However, if we increase the temperature to reach operando conditions the surface undergoes a global dynamical change and the step structure of the Fe(111) surface is destroyed. The catalytic sites, traditionally associated with the Fe(111) surface appear and disappear continuously. Our simulations illuminate the danger of extrapolating low-temperature results to operando conditions and indicate that the catalytic activity can only be inferred from calculations that take dynamics fully into account. More than that, they show that it is the transition to this highly fluctuating interfacial environment that drives the catalytic process.

In situ ball milling of solid catalysts is a promising yet almost unexplored concept for boosting catalytic performance. The continuous preferential oxidation of CO (CO‐PROX) under in situ ball milling of Cu‐based catalysts such as Cu/Cr2O3 is presented. At temperatures as low as −40 °C, considerable activity and more than 95 % selectivity were achieved. A negative apparent activation energy was observed, which is attributed to the mechanically induced generation and subsequent thermal healing of short‐lived surface defects. In situ ball milling at sub‐zero temperatures resulted in an increase of the CO oxidation rate by roughly 4 orders of magnitude. This drastic and highly selective enhancement of CO oxidation showcases the potential of in situ ball milling in heterogeneous catalysis.

No abstract