The effect of molecular weight on the morphology of polystyrene (PS)/poly(methyl methacrylate) (PMMA) composite particles was investigated. PS/PMMA composite particles with different molecular weights (M*=MwPS+MwPMMA)/2 approximately 2x10(4)-1x10(6) g.mol(-1)) were prepared by the release of toluene (T) from PS/PMMA/T (1/1/24, w/w/w) droplets dispersed in an aqueous solution of polyoxyethylene nonylphenyl ether nonionic surfactant (Emulgen 911). As T evaporated, the spherical droplets phase separated, resulting in snowmanlike composite particles with Janus morphology. The nonspherical shape was closely related to the morphology, which depended on M*. The interfacial tension between the phase-separated PS and PMMA phases increased with an increase in M*, and this would allow the formation of the snowmanlike shape to decrease the interfacial area between the PS and the PMMA phases.

The effect of the kind of stabilizers on the formation of "onionlike" multilayered polystyrene-block-poly(methyl methacrylate) (PS-b-PMMA) particles was studied. The release of toluene from PS-b-PMMA/toluene droplets dispersed in aqueous medium resulted in the formation of onionlike multilayered structures in the particles for all stabilizers used. However, the surface composition of the particles was strongly affected by the kind of stabilizer. When sodium dodecyl sulfate (SDS) and poly(vinyl alcohol) (PVA) were used as stabilizers, the surface of the particles was occupied by PMMA phase. On the other hand, in the cases of Emulgen 911 (polyoxyethylene nonylphenyl ether) and Tween 80 (polyoxyethylene sorbitan monooleate) as stabilizers, the PS phase occupied the surfaces. These results for SDS, PVA, and Emulgen 911 are consistent with the surface layer of the PS-b-PMMA particles being occupied by the polymer phase, which gives a lower interfacial tension than that of another phase. However, in the case of Tween 80, interfacial tensions between water and toluene solutions of the polymer showed almost the same values making it impossible to predict the surface polymer phase.

"Snowmanlike" polystyrene (PS)/poly(methyl methacrylate) (PMMA) composite particles were prepared by evaporation of toluene from PS/PMMA/toluene droplets dispersed in an aqueous solution of polyoxyethylene nonylphenyl ether surfactant (Emulgen 911). Partitioning experiments revealed that the Emulgen 911 concentration was higher in the droplets than in the aqueous solution during toluene evaporation. As a consequence, the interfacial tensions between the polymer phases (PS and PMMA) and the aqueous phase (gammaP-T/W) were extraordinarily low (approximately 10(-1) mN/m). The interfacial tension between the PS and PMMA phases containing toluene (gammaPS-T/PMMA-T) measured by the spinning drop method was not affected by the presence of Emulgen 911. Based on minimization of the total interfacial free energy at a polymer weight fraction in the toluene droplet of 0.17, the formation of spherical droplets is expected, in agreement with experiment. The subsequent morphology change of the PS/PMMA/toluene droplets from spherical to snowmanlike during toluene evaporation under thermodynamic equilibrium is attributed to (i) the low values of gammaP-T/W, which explains the increase in the interfacial area between the droplets and the aqueous phase, and (ii) the increase in gammaPS-T/PMMA-T with increasing polymer weight fraction.