Nanofluids have been recently proposed as new chemical agents for enhanced oil recovery from oil reservoirs. Various nanofluids have been studied in that regard and reported in the literature, verifying the capability of nanostructured materials in enhancing the oil recovery through alteration of rock wettability. In this study, the impacts of different nanofluids of zirconium dioxide (ZrO 2 ), calcium carbonate (CaCO 3 ), titanium dioxide (TiO 2 ), silicon dioxide (SiO 2 ), magnesium oxide (MgO), aluminum oxide (Al 2 O 3 ), cerium oxide (CeO 2 ), and carbon nanotube (CNT) on the wettability of carbonate rocks were investigated. A series of preliminary contact angle evaluations were performed to screen the nanoparticles. The performances of the selected nanofluids were evaluated by spontaneous imbibition and core flooding experiments. Results of spontaneous imbibition tests and coreflooding experiments confirm the active roles of CaCO 3 and SiO 2 nanoparticles for enhancing oil recovery. In addition, the effect of nanofluid injection on rock surface wettability was examined by drainage capillary pressure measurement. It is shown that the irreducible water saturation and the entry capillary pressure were both increased after treatment by CaCO 3 nanaofluid. Moreover, the structural disjoining pressure gradient is proposed to be the responsible mechanism for changing wettability. Both experiments and theoretical calculations prove that disjoining pressure of the nanoparticles layer near the contact point can be high enough to remove oil from the surface.

No abstract

No abstract

Dissolution of CO 2 into brine causes the density of the mixture to increase. The density gradient induces natural convection in the liquid phase, which is a favorable process of practical interest for CO 2 storage. Correct estimation of the dissolution rate is important because the time scale for dissolution corresponds to the time scale over which free phase CO 2 has a chance to leak out. However, for this estimation, the challenging simulation on the basis of convection-diffusion equation must be done. In this study, pseudo-diffusion coefficient is introduced which accounts for the rate of mass transferring by both convection and diffusion mechanisms. Experimental tests in fluid continuum and porous media were performed to measure the real rate of dissolution of CO 2 into water during the time. The pseudo diffusion coefficient of CO 2 into water was evaluated by the theory of pressure decay and this coefficient is used as a key parameter to quantify the natural convection and its effect on mass transfer of CO 2 . For each experiment, fraction of ultimate dissolution is calculated from measured pressure data and the results are compared with predicted values from analytical solution. Measured CO 2 mass transfer rate from experiments are in reasonable agreement with values calculated from diffusion equation performed on the basis of pseudo-diffusion coefficient. It is suggested that solving diffusion equation with pseudo diffusion coefficient herein could be used as a simple and rapid tool to calculate the rate of mass transfer of CO 2 in CCS projects.

No abstract

No abstract

No abstract

No abstract