Amlodipine, a dihydropyridine calcium channel blocker, and valsartan, an angiotensin II receptor blocker, are co-formulated in a single-dose combination for the treatment of hypertension. The combination is used by patients whose blood pressure is not adequately controlled on either component monotherapy. This work describes a simple, sensitive, and reliable spectrofluorimetric method for the simultaneous determination of the two antihypertensive drugs; amlodipine besylate (AML) and valsartan (VAL) in their combined tablets. The method involved measurement of the native fluorescence at 455 nm (λ(Ex) 360 nm) and 378 nm (λ(Ex) 245 nm) for AML and VAL, respectively. Analytical performance of the proposed spectrofluorimetric procedure was statistically validated with respect to linearity, ranges, precision, accuracy, selectivity, robustness, detection, and quantification limits. Regression analysis showed good correlation between fluorescence intensity and concentration over the concentration ranges 0.2-3.6 and 0.008-0.080 µg mL⁻¹ for AML and VAL, respectively. The limits of detection were 0.025 and 0.0012 µg mL⁻¹ for AML and VAL, respectively. The proposed method was successfully applied for the assay of the two drugs in their combined pharmaceutical tablets with recoveries not less than 98.85%. No interference was observed from common pharmaceutical additives. The results were favourably compared with those obtained by a reference spectrophotometric method.

No abstract

Simple, rapid, and selective RP-HPLC methods with UV detection were developed for simultaneous determination of chlordiazepoxide hydrochloride and mebeverine hydrochloride (Mixture I) and carvedilol and hydrochlorothiazide (Mixture II). The chromatographic separation in both mixtures was achieved by using an RP-C8 (octylsilyl) analytical column. For Mixture I, a mobile phase composed of acetonitrile0.05 M disodium hydrogen phosphatetriethylamine (50 + 50 + 0.2, v/v/v), pH 2.5, was used; the detector wavelength was 247 nm. For Mixture II, the mobile phase consisted of acetonitrile0.05 M disodium hydrogen phosphate (50 + 50, v/v), pH 4.0, and the detector was set at 220 nm. Quantification of the analytes was based on measuring their peak areas. Both mixtures were resolved in less than 6 min. The reliability and analytical performance of the proposed HPLC procedures were statistically validated with respect to linearity, range, precision, accuracy, selectivity, robustness, LOD, and LOQ. The linear dynamic ranges were 2.5150 and 2.5500 g/mL for chlordiazepoxide HCl and mebeverine HCl, respectively, and 0.25200 and 0.25150 g/mL for carvedilol and hydrochlorothiazide, respectively. The validated HPLC methods were successfully applied to the analysis of their commercial tablet dosage forms, for which no interfering peaks were encountered from common pharmaceutical adjuvants.

A simple, rapid, and highly selective HPLC-DAD method was developed for the simultaneous determination of diclofenac sodium (DIC) and diflunisal (DIF) in pure form and in their combined formulation. Effective chromatographic separation was achieved using a Zorbax SB-C8 (4.6×250 mm, 5 μm particle size) column with a mobile phase composed of 0.05 M phosphoric acid, acetonitrile, and methanol in the ratio of 40:48:12 (by volume). The mobile phase was pumped isocratically at a flow rate of 1 mL/min, and quantification of the analytes was based on measuring their peak areas at 228 nm. The retention times for diflunisal and diclofenac were about 7.9 and 9.5 min, respectively. The reliability and analytical performance of the proposed HPLC procedure were statistically validated with respect to system suitability, linearity, ranges, precision, accuracy, specificity, robustness, detection, and quantification limits. Calibration curves were linear in the ranges of 5–100 μg/mL for both drugs with correlation coefficients >0.9998. The proposed method proved to be selective and stability-indicating by the resolution of the two analytes from four of their related substances and potential impurities as well as from forced-degradation (hydrolysis, oxidation, photolysis, and dry heat) products. The validated HPLC method was successfully applied to the analysis of DIC and DIF in their combined dosage form (suppositories). The proposed method made use of the diode array detector (DAD) as a tool for peak identity and purity confirmation.

In this work, a simple, rapid, and selective high-performance liquid chromatography (HPLC) method with diode array detection was developed for the simultaneous determination of nitrofurazone (NZ) and lidocaine hydrochloride (LD). The chromatographic separation was achieved by using Zorbax Eclipse XDB-C(18) (4.6 x 150 mm, 5 mum p.s.) analytical column and a mobile phase composed of 0.025 M disodium hydrogen phosphate-methanol-triethylamine (70:30:0.1, v/v/v) (pH 4.0) at a flow rate of 1 mL/min. The detector was set at wavelengths 374 and 220 nm for NZ and LD, respectively, and quantification of the analytes was based on measuring their peak areas. The retention times for NZ and LD were approximately 4.5 and 5.7 min, respectively. The reliability and analytical performance of the proposed HPLC procedure were statistically validated with respect to system suitability, linearity, ranges, precision, accuracy, selectivity, robustness, and detection and quantification limits. The linear dynamic ranges were 0.5-25 and 2.5-100 mug/mL for NZ and LD, respectively, with correlation coefficients > 0.999. The stability-indicating aspects of the proposed method were demonstrated by the resolution of the two analytes from the related substance and potential impurity (2,6-dimethylaniline) as well as from forced-degradation products. The validated HPLC method was successfully extended to the analysis of the combined topical dosage form (soluble dressing) where no interfering peaks were encountered from the dosage form matrix or the inactive ingredients.