Atrazine, propazine, and terbuthylazine are chlorotriazine herbicides that have been frequently used in agriculture and thus are potential drinking water contaminants. Hydroxyl radicals produced by advanced oxidation processes can degrade these persistent compounds. These herbicides are also very reactive with sulfate radicals (2.2-3.5 × 10(9) M(-1) s(-1)). However, the dealkylated products of chlorotriazine pesticides are less reactive toward sulfate radicals (e.g., desethyl-desisopropyl-atrazine (DEDIA; 1.5 × 10(8) M(-1) s(-1))). The high reactivity of the herbicides is largely due to the ethyl or isopropyl group. For example, desisopropyl-atrazine (DIA) reacts quickly (k = 2 × 10(9) M(-1) s(-1)), whereas desethyl-atrazine (DEA) reacts more slowly (k = 9.6 × 10(8) M(-1) s(-1)). The tert-butyl group does not have a strong effect on reaction rate, as shown by the similar second order reaction rates between desethyl-terbuthylazine (DET; k = 3.6 × 10(8) M(-1) s(-1)) and DEDIA. Sulfate radicals degrade a significant proportion of atrazine (63%) via dealkylation, in which deethylation significantly dominates over deisopropylation (10:1). Sulfate and hydroxyl radicals react at an equally fast rate with atrazine (k (hydroxyl radical + atrazine) = 3 × 10(9) M(-1) s(-1)). However, sulfate and hydroxyl radicals differ considerably in their reaction rates with humic acids (k (sulfate radical + humic acids) = 6.8 × 10(3) L mgC(-1) s(-1) (mgC = mg carbon); k (hydroxyl radical + humic acids) = 1.4 × 10(4) L mgC(-1) s(-1)). Thus, in the presence of humic acids, atrazine is degraded more efficiently by sulfate radicals than by hydroxyl radicals.
We validated a SPE-CSIA method that allows analysis of isotope ratios of mixtures of pesticides that commonly occur together in environmental water samples.
Studies according to OECD 308 and OECD 309 are performed to simulate the biodegradation of chemicals in water-sediment systems in support of persistence assessment and exposure modeling. However, several shortcomings of OECD 308 have been identified that hamper data evaluation and interpretation, and its relation to OECD 309 is still unclear. The present study systematically compares OECD 308 and OECD 309 and two variants thereof to derive recommendations on how to experimentally address any shortcomings and improve data for persistence and risk assessment. To this end, four (14)C-labeled compounds with different biodegradation and sorption behavior were tested across standard OECD 308 and 309 test systems and two modified versions thereof. The well-degradable compounds showed slow equilibration and the least mineralization in OECD 308, whereas the modified systems provided the highest degree of mineralization. Different lines of evidence suggest that this was due to increased oxygenation of the sediment in the modified systems. Particularly for rapidly degrading compounds, non-extractable residue formation was in line with degradation and did not follow the sediment-water ratio. For the two more slowly degrading compounds, sorption in OECD 309 (standard and modified) increased with time beyond levels proposed by equilibrium partitioning, which could be attributed to the grinding of the sediment through the stirring of the sediment suspension. Overall, the large differences in degradation observed across the four test systems suggest that refined specifications in test guidelines are required to reduce variability in test outcomes. At the same time, the amount of sediment and its degree of oxygenation emerged as drivers across all test systems. This suggests that a unified description of the systems was possible and would pave the way toward a more consistent consideration of degradation in the water-sediment systems across different exposure situations and regulatory frameworks.
Compound-specific isotope analysis (CSIA) of organic water contaminants can provide important information about their sources and fate in the environment. Analyte enrichment from water remains nonetheless a critical yet inevitable step before measurement. Commercially available solid-phase extraction (SPE) sorbents are inherently nonselective leading to co-extraction of concurrent dissolved organic matter (DOM) and in turn to analytical interferences, especially for low-occurring contaminants. Here, we (i) increased extraction selectivity by synthesizing cyclodextrin polymers (α-, β-, γ-CDP) as SPE sorbents, (ii) assessed their applicability to carbon isotope analysis for a selection of pesticides, and (iii) compared them with commonly used commercial sorbents. Extraction with β-CDP significantly reduced backgrounds in gas chromatography-isotope ratio mass spectrometry (GC-IRMS) and enhanced sensitivity by a factor of 7.5, which was further confirmed by lower carbon-normalized C DOM /C analyte ratios in corresponding extracts as derived from dissolved organic carbon (DOC) and liquid chromatography-tandem mass spectrometry (LC-MS/MS) analysis. Gibbs free energies of adsorption demonstrated weak competition between DOM and analyte on the three CDPs. No isotopic fractionation (Δδ 13 C within ± 0.3‰) was observed for the investigated pesticides after using β-CDP as an SPE sorbent covering a range of concentrations (5−500 μg L −1 ), flow velocities (5−40 cm min −1 ), and sorbent regeneration (up to six times). The present study highlights the benefit of selecting innovative extraction sorbents to avoid interferences in advance. This strategy in combination with existing cleanup approaches offers new prospects for CSIA at field concentrations of tens to hundreds of nanograms per liter.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.