The continuous development of esthetically acceptable adhesive restorative material has made a variety of tooth-colored materials available for clinical use. The advent of visible light polymerizing resin and the use of finer filler particles permit resin composites to be polished to higher degree. The effect of polishing systems on surface finish has been reported to be material-dependent, and the effectiveness of these systems was mostly product-dependent. Hence, the purpose of this study was to evaluate the efficiency of finishing and polishing systems on the surface roughness of nanofilled, microfilled, and hybrid composite restorative materials available in the market.How to cite this articleYadav RD, Raisingani D, Jindal D, Mathur R. A Comparative Analysis of Different Finishing and Polishing Devices on Nanofilled, Microfilled, and Hybrid Composite: A Scanning Electron Microscopy and Profilometric Study. Int J Clin Pediatr Dent 2016;9(3):201-208.
The study concludes that two different methods i.e. bacterial and dye leakage revealed considerable variation on the same substrate Thus, due to the presence of variability among the results obtained by two different analytical methods used in the present study, the study emphasizes the need for standardization of methods as the lack of standardization hinders the comparison of different endodontic filling techniques.
The four groups were comparable in canal volume. The overall POV was 78.11%, 85.72%, 82.50%, and 87.89% for lateral compaction, Thermafil, Obtura II, and Calamus, respectively (P Conclusion: The greatest POV was obtained with Calamus and Thermafil. Voids were seen in all root fillings.
AimTo evaluate the incidence of apical crack initiation during canal preparation with stainless steel K-files and hand protaper files (in vitro study).Materials and methodsSixty extracted mandibular premo-lar teeth are randomly selected and embedded in an acrylic tube filled with autopolymerizing resin. A baseline image of the apical surface of each specimen was recorded under a digital microscope (80×). The cervical and middle thirds of all samples were flared with #2 and #1 Gates-Glidden (GG) drills, and a second image was recorded. The teeth were randomly divided into four groups of 15 teeth each according to the file type (hand K-file and hand-protaper) and working length (WL) (instrumented at WL and 1 mm less than WL). Final image after dye penetration and photomicrograph of the apical root surface were digitally recorded.ResultsMaximum numbers of cracks were observed with hand protaper files compared with hand K-file at the WL and 1 mm short of WL. Chi-square testing revealed a highly significant effect of WL on crack formation at WL and 1 mm short of WL (p = 0.000).ConclusionMinimum numbers of cracks at WL and 1 mm short of WL were observed with hand K-file and maximum with hand protaper files.How to cite this articleSoni D, Raisingani D, Mathur R, Madan N, Visnoi S. Incidence of Apical Crack Initiation during Canal Preparation using Hand Stainless Steel (K-File) and Hand NiTi (Protaper) Files. Int J Clin Pediatr Dent 2016;9(4):303-307.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.