No abstract

Polystyrene and poly(vinyl alcohol) nanofibres containing cellulose nanocrystals (CNCs) were successfully produced by electrospinning. Knowledge of the local orientation of CNCs in electrospun fibres is critical to understand and exploit their mechanical properties. The orientation of CNCs in these electrospun fibres was investigated using transmission electron microscopy (TEM) and Raman spectroscopy. A Raman band located at *1095 cm -1 , associated with the C-O ring stretching of the cellulose backbone, was used to quantify the orientation of the CNCs within the fibres. Raman spectra were fitted using a theoretical model to characterize the extent of orientation. From these data, it is observed that the CNCs have little orientation along the direction parallel to the axis of the fibres. Evidences for both oriented and nonoriented regions of CNCs in the fibres are presented from TEM images of nanofibres. These results contradict previously published work in this area and micromechanical modelling calculations suggest a uniform orientation of CNCs in electrospun polymer fibres. It is demonstrated that this explains why the mechanical properties of electrospun fibre mats containing CNCs are not always the same as that would be expected for a fully oriented system.

Lignocellulosic sisal fiber (LSF) and sisal pulp (SP) were electrospun at room temperature from solutions in trifluoroacetic acid (TFA) prepared at concentrations of 2 3 10 22 g mL 21 and 3 3 10 22 g mL 21 , respectively. Scanning electron microscopy images of the electrospun LSF showed fibers with diameters ranging from 120 to 510 nm. The presence of defects decreased along with increasing the flow rate of the SP solution, which generated nanofibers and ultrathin fibers with diameters in the range of 40-60 (at 5.5 mL min 21 ) up to 90-200 nm (at 65.5 mL min 21 ). Despite the known ability of TFA to esterify the hydroxyl groups present in the starting materials, the Fourier transform infrared spectra indicated the absence of trifluoroacetyl groups in the electrospun samples. The thermal stability of the final materials proved suitable for many applications even though some differences were observed relative to the starting materials. This study demonstrated a feasible novel approach for producing nano/ultrathin fibers from lignocellulosic biomass or its main component, which allows for a wide range of applications for these materials.

No abstract