[1] We use interferometric synthetic aperture radar (InSAR), body wave seismology, satellite imagery, and field observations to constrain the fault parameters of the M w 7.1 2011 Van (Eastern Turkey) reverse-slip earthquake, in the Turkish-Iranian plateau. Distributed slip models from elastic dislocation modeling of the InSAR surface displacements from ENVISAT and COSMO-SkyMed interferograms indicate up to 9 m of reverse and oblique slip on a pair of en echelon NW 40°-54°dipping fault planes which have surface extensions projecting to just 10 km north of the city of Van. The slip remained buried and is relatively deep, with a centroid depth of 14 km, and the rupture reaching only within 8-9 km of the surface, consistent with the lack of significant ground rupture. The up-dip extension of this modeled WSW striking fault plane coincides with field observations of weak ground deformation seen on the western of the two fault segments and has a dip consistent with that seen at the surface in fault gouge exposed in Quaternary sediments. No significant coseismic slip is found in the upper 8 km of the crust above the main slip patches, except for a small region on the eastern segment potentially resulting from the M w 5.9 aftershock on the same day. We perform extensive resolution tests on the data to confirm the robustness of the observed slip deficit in the shallow crust. We resolve a steep gradient in displacement at the point where the planes of the two fault segments ends are inferred to abut at depth, possibly exerting some structural control on rupture extent.
Geosynchronous synthetic aperture radar (GEO SAR) has been studied for several decades but has not yet been implemented. This paper provides an overview of mission design, describing significant constraints (atmosphere, orbit, temporal stability of the surface and atmosphere, measurement physics, and radar performance) and then uses these to propose an approach to initial system design. The methodology encompasses all GEO SAR mission concepts proposed to date. Important classifications of missions are: 1) those that require atmospheric phase compensation to achieve their design spatial resolution; and 2) those that achieve full spatial resolution without phase compensation. Means of estimating the atmospheric phase screen are noted, including a novel measurement of the mean rate of change of the atmospheric phase delay, which GEO SAR enables. Candidate mission concepts are described. It seems likely that GEO SAR will be feasible in a wide range of situations, although extreme weather and unstable surfaces (e.g., water, tall vegetation) prevent 100% coverage. GEO SAR offers an exciting imaging capability that powerfully complements existing systems.
The North Anatolian Fault (NAF) is a major feature of Middle Eastern tectonics, and several previous InSAR studies have measured interseismic deformation across the fault. All previous studies, however, have used SAR data acquired from a single line‐of‐sight (LOS) direction, leading to large uncertainties on model parameters and necessitating several modelling assumptions to be made. We have measured interseismic deformation across the NAF using both ascending and descending SAR data for the first time, an aim that has previously been limited by the availability of ascending data. By using SAR data from two look directions we have been able to reduce the range of uncertainties in slip rate and locking depth from previous studies by 60%, and by assuming no vertical motion across the fault, we estimate both fault‐normal and fault‐parallel motion. These results support other evidence for predominantly horizontal strike‐slip motion on the NAF. Our data are consistent with a slip rate of 20–26 mm/yr below a locking depth of 13.5–25 km for the NAF.
The temporal variability of the atmosphere through which radio waves pass in the technique of differential radar interferometry can seriously limit the accuracy with which the method can measure surface motion. A forward, nested mesoscale model of the atmosphere can be used to simulate the variable water content along the radar path and the resultant phase delays. Using this approach we demonstrate how to correct an interferogram of Mount Etna in Sicily associated with an eruption in 2004-5. The regional mesoscale model (Unified Model) used to simulate the atmosphere at higher resolutions consists of four nested domains increasing in resolution (12, 4, 1, 0.3 km), sitting within the analysis version of a global numerical model that is used to initiate the simulation. Using the high resolution 3D model output we compute the surface pressure, temperature and the water vapour, liquid and solid water contents, enabling the dominant hydrostatic and wet delays to be calculated at specific times corresponding to the acquisition of the radar data. We can also simulate the second-order delay effects due to liquid water and ice.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.