Burn-up measurement on an irradiated mixed oxide (MOX) test fuel pellet was carried out through measurements on the dissolver solution by HPLC-Thermal Ionization Mass Spectrometric (TIMS) technique. The studies carried out using HPLC as well as TIMS for quantification of burn-up value are described. While in one case, both the separation and determination of elements of interest (U, Pu and Nd) were carried out by HPLC; in another case, TIMS technique was used to quantify them from the HPLC separated fractions. The rapid separation procedures developed in our laboratory earlier were employed to isolate pure fractions of the desired elements. The individual lanthanide fission products (La to Eu) were separated from each other using dynamic ion-exchange chromatographic technique whereas uranium and plutonium were separated from each other using reversed phase chromatographic technique. The pure fractions of U, Pu and Nd obtained after HPLC separation procedure for "spiked" and "unspiked" dissolver solutions were used in TIMS measurements for the first time in our laboratory. In TIMS analysis, isotopic abundances of uranium, plutonium and neodymium fractions obtained from HPLC separation procedure on an "unspiked" fuel sample were measured. Nd were employed as spikes). The burn-up values from duplicate spiking experiments were computed based on the summation of 145 Nd + 146 Nd. The concentrations of neodymium, uranium and plutonium were also measured using HPLC with post-column derivatisation technique using aresenazo(III) as the post-column reagent. The atom % burn-up computed from HPLC and TIMS techniques were in good agreement.
Rate of evaporation of Sm and Nd from their mixture was studied based on their ion intensities using thermal ionization mass spectrometry. Because of the comparatively larger evaporation rate of Sm, it was found possible to get the isotopic composition of Nd (fission product monitor) free from isobaric interference of Sm isotopes. The decrease in ion intensity of Sm was studied as a function of time and filament temperature. Based on this study, an easy and time effective method for the determination of burn-up of spent nuclear fuel was examined and the results are compared with that obtained by the conventional method. Typical burn-up value obtained for a pressurized heavy water reactor fuel dissolver solution using the direct method by preferential evaporation of Sm is: 0.84 at.%, whereas the one obtained by the use of conventional method is 0.82 at.%. In both the cases, Nd was employed as the fission product monitor.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.