No abstract

No abstract

Milk from French-Alpine goats and Holstein cows was obtained from a bulk tank immediately prior to analyses. Fat globule size was determined by laser particle size analysis. Individual globules of fat in goat milk ranged from 0.73 to 8.58 microm in diameter. The average diameter of particles based on volume to surface area ratio (dvs) was 2.76 microm and was less than the mean (dvs) of 3.51 microm for bovine milk, in which fat globules ranged from 0.92 to 15.75 microm in diameter. The specific surface area of particles in caprine milk was 21,778 cm2/ml, whereas the specific surface area of particles in bovine milk was 17,117 cm2/ml. Ninety percent of the total particles found in goat milk were less than 5.21 microm in diameter, whereas 90% of the total particles in bovine milk were less than 6.42 microm based on the volume frequency distribution. Dissociation of casein micelles by urea in goat whole and skim milk caused larger dvs values due to the effect of fat particles and reduced the specific surface area in both milks because the total number of detectable particles in both whole and skim milk was reduced.

Average diameters and particle size distributions in fluid milks with different fat contents and subjected to various homogenization pressures with a "microfluidizer" were evaluated. Skim, 2%, and whole milks were microfluidized at 50, 100, 150, and 200 MPa. Cream containing 41% milk fat was microfluidized at 50, 100, and 150 MPa. Particle sizes were determined by laser light scattering. As microfluidization pressure was increased from 50 to 100 MPa, particle sizes in skim, 2%, and whole milks decreased. Microfluidization at pressures greater than 100 MPa had little additional effect on reducing the particle sizes in skim and 2% milks compared with microfluidization at 100 MPa, but the particle sizes in whole milk increased as the microfluidization pressure was increased from 100 to 200 MPa due to formation of homogenization clusters. The particle sizes in cream increased as the microfluidization pressure was increased from 50 to 150 MPa. When the microfluidization pressure was held constant, the particle sizes increased as the milk fat concentration was increased. The coefficients of variations of the volume-weighted particle size distributions for cream were higher than for skim, 2%, and whole milks. Larger "big" particles and smaller "small" particles were formed in whole milk after microfluidization at 200 MPa than at 100 MPa. Although microfluidization can be used to produce small particles in skim, 2%, and whole milks, a higher than optimum pressure (above 100 MPa) applied to whole milk will not lead to the minimum d(43) (volume-weighted average diameter) due to formation of clusters.

No abstract