High tolerance chip capacitors are at best expensive and at the worst unobtainable. When asked to custom build a small signal circuit containing close tolerance RC networks it became obvious that functional resistor trimming was unavoidable if suitable quantities were to be produced at the right price.The product which is shown in Figure is constructed by conventional thick film techniques. It uses a l"x 2" alumina substrate and attached com- 2) The majority of the resistors are trimmed prior to the attachment of the discrete components, using an air abrasive system. The high tolerance, high stability resistors required (top left hand corner of Figure 1) are glazed prior to trimming to increase their stability, to give protection from the encapsulating epoxy, and to warn the trimmer operator that extra care is required.The circuit produces rectangular pulses of set width at a repetition rate of the order of 15 kHz with a mark space ratio of 5:1. These parameters are determined by the time FIGURE Complete thick film hybrid circuit.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.