Modern high-power lasers can generate extreme states of matter that are relevant to astrophysics, equation-of-state studies and fusion energy research. Laser-driven implosions of spherical polymer shells have, for example, achieved an increase in density of 1,000 times relative to the solid state. These densities are large enough to enable controlled fusion, but to achieve energy gain a small volume of compressed fuel (known as the 'spark') must be heated to temperatures of about 108 K (corresponding to thermal energies in excess of 10 keV). In the conventional approach to controlled fusion, the spark is both produced and heated by accurately timed shock waves, but this process requires both precise implosion symmetry and a very large drive energy. In principle, these requirements can be significantly relaxed by performing the compression and fast heating separately; however, this 'fast ignitor' approach also suffers drawbacks, such as propagation losses and deflection of the ultra-intense laser pulse by the plasma surrounding the compressed fuel. Here we employ a new compression geometry that eliminates these problems; we combine production of compressed matter in a laser-driven implosion with picosecond-fast heating by a laser pulse timed to coincide with the peak compression. Our approach therefore permits efficient compression and heating to be carried out simultaneously, providing a route to efficient fusion energy production.

No abstract

The problem of the 'hole-boring' (HB)-type of radiation pressure acceleration of ions by circularly polarized laser pulses interacting with overdense plasmas is considered in the regime where the dimensionless scaling parameter I/ρc 3 becomes large. In this regime a non-relativistic treatment of the 'HB' problem is no longer adequate. A new set of fully relativistic formulae for the mean ion energy and 'HB' velocity is derived and validated against one-dimensional particle-in-cell simulations. It is also found that the finite acceleration time of the ions results in large energy spreads in the accelerated ion beam even under the highly idealized conditions of constant laser intensity and uniform mass density.

We present measurements of a magnetic reconnection in a plasma created by two laser beams (1 ns pulse duration, 1 x 10(15) W cm(-2)) focused in close proximity on a planar solid target. Simultaneous optical probing and proton grid deflectometry reveal two high velocity, collimated outflowing jets and 0.7-1.3 MG magnetic fields at the focal spot edges. Thomson scattering measurements from the reconnection layer are consistent with high electron temperatures in this region.

International audienceThe spectra of energetic electrons produced by a laser interaction with underdense plasma have been measured at intensities >3×10^20  W cm^-2. Electron energies in excess of 300 MeV have been observed. Measurements of the transmitted laser spectrum indicate that there is no correlation between the acceleration of electrons and plasma wave production. Particle-in-cell simulations show that the laser ponderomotive force produces an ion channel. The interaction of the laser field with the nonlinear focusing force of the channel leads to electron acceleration. The majority of the electrons never reach the betatron resonance but those which gain the highest energies do so. The acceleration process exhibits a strong sensitivity to initial conditions with particles that start within a fraction of a laser wavelength following completely different trajectories and gaining markedly different energies

Metal foil targets were irradiated with 1 mum wavelength (lambda) laser pulses of 5 ps duration and focused intensities (I) of up to 4x10;{19} W cm;{-2}, giving values of both Ilambda;{2} and pulse duration comparable to those required for fast ignition inertial fusion. The divergence of the electrons accelerated into the target was determined from spatially resolved measurements of x-ray K_{alpha} emission and from transverse probing of the plasma formed on the back of the foils. Comparison of the divergence with other published data shows that it increases with Ilambda;{2} and is independent of pulse duration. Two-dimensional particle-in-cell simulations reproduce these results, indicating that it is a fundamental property of the laser-plasma interaction.

Measurements of energetic electron beams generated from ultrahigh intensity laser interactions (I>10(19) W/cm(2)) with dense plasmas are discussed. These interactions have been shown to produce very directional beams, although with a broad energy spectrum. In the regime where the beam density approaches the density of the background plasma, we show that these beams are unstable to filamentation and "hosing" instabilities. Particle-in-cell simulations also indicate the development of such instabilities. This is a regime of particular interest for inertial confinement fusion applications of these beams (i.e., "fast ignition").

Target studies for the proposed High Power Laser Energy Research (HiPER) facility [M. Dunne, Nature Phys. 2, 2 (2006)] are outlined and discussed. HiPER will deliver a 3 omega (wavelength lambda=0.35 mu m), multibeam, multi-ns pulse of about 250 kJ and a 2 omega or 3 omega pulse of 70-100 kJ in about 15 ps. Its goal is the demonstration of laser driven inertial fusion via fast ignition. The baseline target concept is a direct-drive single shell capsule, ignited by hot electrons generated by a conically guided ultraintense laser beam. The paper first discusses ignition and compression requirements, and presents gain curves, based on an integrated model including ablative drive, compression, ignition and burn, and taking the coupling efficiency eta(ig) of the igniting beam as a parameter. It turns out that ignition and moderate gain (up to 100) can be achieved, provided that adiabat shaping is used in the compression, and the efficiency eta(ig) exceeds 20%. Using a standard ponderomotive scaling for the hot electron temperature, a 2 omega or 3 omega ignition beam is required to make the hot electron range comparable to the desired size of the hot spot. A reference target family is then presented, based on one-dimensional fluid simulation of compression, and two-dimensional fluid and hybrid simulations of fast electron transport, ignition, and burn. The sensitivity to compression pulse shape, as well as to hot electron source location, hot electron range, and beam divergence is also discussed. Rayleigh-Taylor instability at the ablation front has been addressed by a model and a perturbation code. Simplified simulations of code-guided target implosions have also been performed. (c) 2008 American Institute of Physics