MELTSIM 1.0 is available at: //www.uml.edu/Dept/Chem/UMLBIC/Apps/MEL TSIM/MELTSIM-1.0-Win/meltsim. zip. Melting curve plots in this paper were made with GNUPLOT 3.5, available at: http://www.cs.dartmouth.edu/gnuplot_inf o.html Contact : blake@maine.maine.edu;

Tij and Delta Hij for stacking of pair i upon j in DNA have been obtained over the range 0.034-0.114 M Na+from high-resolution melting curves of well-behaved synthetic tandemly repeating inserts in recombinant pN/MCS plasmids. Results are consistent with neighbor-pair thermodynamic additivity, where the stability constant, sij , for different domains of length N depend quantitatively on the product of stability constants for each individual pair in domains, sijN . Unit transition enthalpies with average errors less than +/-5%, were determined by analysis of two-state equilibria associated with the melting of internal domains and verified from variations of Tij with [Na+]. Enthalpies increase with Tij , in close agreement with the empirical function: Delta Hij = 52.78@ Tij - 9489, and in parallel with a smaller increase in Delta Sij . Delta Hij and Delta Sij are in good agreement with the results of an extensive compilation of published Delta Hcal and Delta Scal for synthetic and natural DNAs. Neighbor-pair additivity was also observed for (dA@dT)-tracts at melting temperatures; no evidence could be detected of the familiar and unusual structural features that characterize tracts at lower temperatures. The energetic effects of loops were determined from the melting behavior of repeating inserts installed between (G+C)-rich barrier domains in the pN/MCSplasmids. A unique set of values for the cooperativity, loop exponent and stiffness parameters were found applicable to internal domains of all sizes and sequences. Statistical mechanical curves calculated with values of Tij([Na+]) , Delta Hij and these loop parameters are in good agreement with observation.

The numbers and local sequence environments of the two types of substitution mutation plus additions and deletions have been obtained directly in this study from differences between a large number of extant primate gene and pseudogene sequences. A total of 3786 mutations were scored in regions where similarities between pseudogene and corresponding gene sequences is greater than or equal to 85%, comprising approximately 30% of the pseudogene database of 80,584 bp. The pattern of mutations obtained in this fashion is almost identical to that obtained by Li et al. (1984) using a slightly different, more direct approach and with a smaller database. When mutations were scored, the neighbor pairs on the 5' and 3' sides were also noted, leading to a large 16 x 12 matrix of transitions and transversions. Biases of varying magnitude are found in the rates of substitution of the same base pair in different local sequence environments. The overall order for the effect of the 5' neighbor on the rates of substitution mutation of a pyrimidine is A greater than C much greater than T greater than G, and G greater than A greater than T greater than C for the 3' neighbor; where these results represent the average of substitution rates for the complement purine with complement neighbors of bases ordered above. The order for the 3' neighbor is essentially the same for the two transitions and most of the four transversions as well; however, the order for the 5' neighbor is more variable. The overall rate for the C.G----T.A transition is not unusual, however the presence of a 3' neighboring G.C pair boosts the rate substantially, presumably due to specific cytosine methylation of the CG doublet in primate DNAs. The rate of the T.A----C.G transition is also well above average when the 3' neighbor is an A.T, and to a lesser extent a G.C, pair. The latter bias is typical in that it reflects the association of alternating pyrimidine-purine sequences with increasing mutation rates. The substitution of the pyrimidine in a 5'purine-pyrimidine-purine3' sequence generally occurs much faster than in a pyrimidine tract and points to the local conformation as a major determining factor of the substitution rate. An apparent inverse relationship is found between starting and product doublet frequencies of base pairs undergoing mutations with specific 3' neighbors, indicating that differences in intrinsic substitution rates of base pairs with specific neighbors are a key factor in producing the familiar biases of nearest-neighbor frequencies.

No abstract

Formamide lowers melting temperatures (Tm) of DNAs linearly by 2.4-2.9 degrees C/mole of formamide (C(F)) depending on the (G+C) composition, helix conformation and state of hydration. The inherent cooperativity of melting is unaffected by the denaturant. dTm/dC(F)for 11 plasmid domains of 0.23 < (G+C)<0.71 generally fit to a linear dependence on (G+C)-content, which, however, is consistent with a (G+C)-independent alteration in the apparent equilibrium constant for thermally induced helix <--> coil transitions. Results indicate that formamide has a destabilizing effect on the helical state, and that sequence-dependent variations in hydration patterns are primarily responsible for small variations in sensitivity to the denaturant. The average unit transition enthalpy delta H(m)[see text for complete expression], exhibits a biphasic dependence on formamide concentration. The initial drop of -0.8 kcal/mol bp at low formamide concentrations is attributable to a delta delta H(m)[see text for complete expression], for exchange of solvent in the vicinity of the helix: displacement by formamide of weakly bound hydrate or counterion. The phenomenological effects are equivalent to lowering the bulk counterion concentration. Poly(dA.dT) exhibits a much lower sensitivity to formamide, due to the specific pattern of tightly bound, immobilized water bridges that buttress the helix from within the narrow minor groove. Tracts of three (A.T)-pairs behave normally, but tracts of six exhibit the same level of reduced sensitivity as the polymer, suggesting a conformational shift as tracts are elongated beyond some critical length [McCarthy J.G. and Rich,A. (1991) Nucleic Acids Res. 19, 3421-3429].