Electro-caloric effect in 0.45BaZr0.2Ti0.8O3-0.55Ba0.7Ca0.3TiO3 single crystal has been investigated and electro-caloric coefficient of ∼0.38 K mm/kV has been obtained near the tetragonal-to-cubic phase transition. The value obtained is significantly higher than that for the lead-free ferroelectric materials reported so far.

Energy of the indirect and direct optical bandgap of nearstoichiometric lithium niobate (nSLN) crystals is evaluated by optical absorption measurement. The value of the indirect bandgap (3.95 eV) is consistent with the earlier reports. However, the direct bandgap energy of 4.12 eV is higher than the previously reported experimental value (3.68 eV). The direct bandgap energy obtained here is closer to the recent theoretical value estimated by Thierfelder et al. [Phys. Status Solidi C 7, 362 (2010)] in comparison to the previously predicted value by Ching et al. [Phys. Rev. B 50, 1992(1994]. The phonons involved in the indirect allowed transitions have energies $85 meV (685 cm À1 ) and are identified as the E(TO9) and E(LO8) optical phonon modes from the Raman scattering measurement.

We present temperature-dependent refractive index along crystallographic b[010] and a direction perpendicular to (100)-plane for monoclinic phase (β) Ga(2)O(3) single crystal grown by the optical floating zone technique. The experimental results are consistent with the theoretical result of Litimein et al.1. Also, the Sellmeier equation for wavelengths in the range of 0.4-1.55 μm is formulated at different temperatures in the range of 30-175 °C. The thermal coefficient of refractive index in the above specified range is ~10(-5)/°C.

A single crystal of lithium niobate is an important optoelectronic material. It can be grown from direct melt only in a lithium deficient non-stoichiometric form as its stoichiometric composition exhibits incongruent melting. As a result it contains a number of intrinsic point defects such as Li-vacancies, Nb antisites, oxygen vacancies, as well as different types of polarons and bipolarons. All these defects adversely influence its optical and ferroelectric properties and pose a deterrent to the effective use of this material. Hence, controlling the defects in lithium niobate has been an exciting topic of research and development over the years. In this article we discuss the different methods of controlling the intrinsic defects in lithium niobate and a comparison of the effect of these methods on the crystalline quality, stoichiometry, optical absorption in the UV-vis region, electronic band-gap, and refractive index.

No abstract

No abstract

No abstract

No abstract