This article reports on the International Nanofluid Property Benchmark Exercise, or INPBE, in which the thermal conductivity of identical samples of colloidally stable dispersions of nanoparticles or "nanofluids," was measured by over 30 organizations worldwide, using a variety of experimental approaches, including the transient hot wire method, steady-state methods, and optical methods. The nanofluids tested in the exercise were comprised of aqueous and nonaqueous basefluids, metal and metal oxide particles, near-spherical and elongated particles, at low and high particle concentrations. The data analysis reveals that the data from most organizations lie within a relatively narrow band ͑Ϯ10% or less͒ about the sample average with only few outliers. The thermal conductivity of the nanofluids was found to increase with particle concentration and aspect ratio, as expected from classical theory. There are ͑small͒ systematic differences in the absolute values of the nanofluid thermal conductivity among the various experimental approaches; however, such differences tend to disappear when the data are normalized to the measured thermal conductivity of the basefluid. The effective medium theory developed for dispersed particles by Maxwell in 1881 and recently generalized by Nan et al. ͓J. Appl. Phys. 81, 6692 ͑1997͔͒, was found to be in good agreement with the experimental data, suggesting that no anomalous enhancement of thermal conductivity was achieved in the nanofluids tested in this exercise.

With the aim of providing reliable benchmark values, we have measured the Soret, thermodiffusion and molecular diffusion coefficients for the ternary mixture formed by 1,2,3,4-tetrahydronaphthalene, isobutylbenzene and n-dodecane for a mass fraction of 0.8-0.1-0.1 and at a temperature of 25°C. The experimental techniques used by the six participating laboratories are Optical Digital Interferometry, Taylor Dispersion technique, Open Ended Capillary, Optical Beam Deflection, Thermogravitational technique and Sliding Symmetric Tubes technique in ground conditions and Selectable Optical Diagnostic Instrument (SODI) in microgravity conditions. The measurements obtained in the SODI installation have been analyzed independently by four laboratories. Benchmark values are proposed for the thermodiffusion and Soret coefficients and for the eigenvalues of the diffusion matrix in ground conditions, and for Soret coefficients in microgravity conditions.

No abstract

Q1We report on thermodiffusion experiments conducted on the International Space Station ISS during fall 2016. These experiments are part of the DCMIX (Diffusion and thermodiffusion Coefficients Measurements in ternary Mixtures) project, which aims at establishing a reliable data base of non-isothermal transport coefficients for selected ternary liquid mixtures. The third campaign, DCMIX3, focuses on aqueous systems with water/ethanol/triethylene glycol as an example, where sign changes of the Soret coefficient have already been reported for certain binary subsystems. Investigations have been carried out with the SODI (Selectable Optical Diagnostics Instrument) instrument, a Mach-Zehnder interferometer set up inside the Microgravity Science Glovebox in the Destiny Module of the ISS. Concentration changes within the liquids have been monitored in response to an external temperature gradient using phase-stepping interferometry. The complete data set has been made available in spring 2017. Due to additionally available measurement time, it was possible to collect a complete data set at 30 • C and an almost complete data set at 25 • C, which significantly exceeds the originally envisaged measurements at a single temperature only. All samples could be measured successfully. The SODI instrument and the DCMIX experiments have proven reliable and robust, allowing to extract meaningful data even in case of unforeseen laser instabilities. First assessments of the data quality have revealed six out of 31 runs with some problems in image contrast and/or phase step stability that will require more sophisticated algorithms. This publication documents all relevant parameters of the conducted experiments and also events that might have an influence on the final results. The compiled information is intended to serve as a starting point for all following data evaluations. Q2

This paper describes the European Space Agency (ESA) experiments devoted to study thermodiffusion of fluid mixtures in microgravity environment, where sedimentation and convection do not affect the mass flow induced by the Soret effect. First, the experiments performed on binary mixtures in the IVIDIL and GRADFLEX experiments are described. Then, further experiments on ternary mixtures and complex fluids performed in DCMIX and planned to be performed in the context of the NEUF-DIX project are presented. Finally, multi-component mixtures studied in the SCCO project are detailed.

Below are the queries associated with your article. Please answer all of these queries before sending the proof back to AIP. Article checklist: In order to ensure greater accuracy, please check the following and make all necessary corrections before returning your proof. 1. Is the title of your article accurate and spelled correctly? 2. Please check affiliations including spelling, completeness, and correct linking to authors. 3. Did you remember to include acknowledgment of funding, if required, and is it accurate? Location in article Query/Remark: click on the Q link to navigate to the appropriate spot in the proof. There, insert your comments as a PDF annotation. Q1 Please check that the author names are in the proper order and spelled correctly. Also, please ensure that each author's given and surnames have been correctly identified (given names are highlighted in red and surnames appear in blue). Q2 Q10 Please confirm the change in volume number in Ref. 2. Q11 References 3 and 18 contain identical information. Please check and provide the correct reference or delete the duplicate reference. If the duplicate is deleted, renumber the reference list as needed and update all citations in the text. Q12 We were unable to locate a digital object identifier (doi) for Ref. 17. Please verify and correct author names and journal details (journal title, volume number, page number, and year) as needed and provide the doi. If a doi is not available, no other information is needed from you. For additional information on doi's, please select this link: http//www.doi.org/.

No abstract

Thermodiffusion, which leads to a component separation in a mixture due to the thermal gradient, still does not have an unambiguous microscopic picture. Therefore, experimental studies, especially in convection free environment, are important. As part of the 4th campaign on the DCMIX project, thermodiffusion experiments on three compositions of the toluene-methanol-cyclohexane ternary mixture, on a mixture of fullerene-tetrahydronaphthalene-toluene and on a mixture of polystyrene-toluene-cyclohexane have been performed in microgravity conditions on board the International Space Station. A binary mixture of polystyrene-toluene has been filled into the companion cell for the campaign. The Selectable Optical Diagnostics Instrument (SODI), wich is a two-wavelength Mach-Zehnder interferometer for the ternary mixtures, plus a monochromatic Mach-Zehnder interferometer for the binary mixture, has been used in order to obtain the temperature and the concentration fields in the cells. Precisely, it is a 5-steps phase-shifting interferometry technique which is implemented with SODI, producing by means of laser illumination a set of 5 phase-shifted images of between them as function of the time. A total of 58 runs of various durations and at different mean temperatures have been conducted. Here, we evaluate the contrast of the interferograms, the quality in the phase stepping, the stability of the thermal regulation of the experiments and the level of environmental disturbances on board the space station during the campaign.