No abstract

With the rapid development of the Internet of things (IoT), flexible piezoelectric nanogenerators (PENG) have attracted extensive attention for harvesting environmental mechanical energy to power electronics and nanosystems. Herein, porous piezoelectric fillers with samarium/titanium-doped BiFeO 3 (BFO) are prepared by a freeze-drying method, and then silicone rubber is filled into the microvoids of the piezoelectric ceramics, forming a unique structure based on silicone rubber matrix with uniformly distributed piezoelectric ceramic. When subjected to external force stimulation, compared with conventional piezocomposite films found on undoped BFO without a porous structure, the PENG possesses higher stress transfer ability and thus boosts output performance. The notable enhancement in the stress transfer ability and piezoelectric potential is proven by COMSOL simulations. The PENG can exhibit a maximum open-circuit voltage (V oc ) of 16 V and shortcircuit current (I sc ) of 2.8 µA, which is 5.3 and 5.6 times higher than those of conventional piezocomposite films, respectively. The PENG can be used as a triggering signal to control the operation of fire extinguishers and household appliances. This work not only expands the application scope of lead-free piezoelectric ceramic for energy harvesting, but also provides a novel solution for self-powered mechanosensation and shows great potential application in IoT.

The hybridization of different materials for energy scavenging techniques based on piezoelectric and triboelectric effects has been studied widely for various applications of nanogenerators. However, there are few reports utilizing the same oxide matrix materials with appropriate doping to simultaneously enhance the piezoelectric and triboelectric outputs. Herein, a hybrid nanogenerator (HG) consisting of a piezoelectric nanogenerator (PENG) and a triboelectric nanogenerator (TENG) was constructed using (Ba0.838Ca0.162)(Ti0.9072Zr0.092)O3 (BCZTO)/polydimethylsiloxane (PDMS) as a piezoelectric layer and Ba(Ti0.8Zr0.2)O3 (BZTO)/PDMS as a triboelectric layer. For the PENG, how the electrical output was related to the BCZTO ratio in the BCZTO/PDMS composite films was systematically investigated. For the TENG, remarkably enhanced output performance is attributed to the ferroelectric polarization and large permittivity of the BZTO/PDMS. The Kelvin probe force microscopy measurements show that the poled BZTO/PDMS composite film with a 20 wt. % mass ratio of BZTO has the highest surface charge potential, in line with the macroscopic electrical outputs of the TENG. Interestingly, the output performance of the PENG in the HG is significantly enhanced compared to the PENG acting alone, which is also verified by COMSOL simulation. After rectification, the HG can produce a maximum output voltage of 390 V and a current density of 47 mA/m2. This work not only provides a feasible solution to enhance the output performance of the HG but also offers an effective approach to develop a small, portable power source with promising application in self-powered electronics.

No abstract