Beamforming technology is an essential method in acoustic imaging or reconstruction, which has been widely used in sound source localization and noise reduction. The beamforming algorithm can be described as all microphones in a plane simultaneously recording the source signal. The source position is then localized by maximizing the result of the beamformer. Evidence has shown that the accuracy of the sound source localization in a 2D plane can be improved by the non-synchronous measurements of moving the microphone array. In this paper, non-synchronous measurements are applied to 3D beamforming, in which the measurement array envelops the 3D sound source space to improve the resolution of the 3D space. The entire radiated object is covered better by a virtualized large or high-density microphone array, and the range of beamforming frequency is also expanded. The 3D imaging results are achieved in different ways: the conventional beamforming with a planar array, the non-synchronous measurements with orthogonal moving arrays, and the non-synchronous measurements with non-orthogonal moving arrays. The imaging results of the non-synchronous measurements are compared with the synchronous measurements and analyzed in detail. The number of microphones required for measurement is reduced compared with the synchronous measurement. The non-synchronous measurements with non-orthogonal moving arrays also have a good resolution in 3D source localization. The proposed approach is validated with a simulation and experiment.
Artificial intelligence and distributed algorithms have been widely used in mechanical fault diagnosis with the explosive growth of diagnostic data. A novel intelligent fault diagnosis system framework that allows intelligent terminals to offload computational tasks to Mobile edge computing (MEC) servers is provided in this paper, which can effectively address the problems of task processing delays and enhanced computational complexity. As the resources at the MEC and intelligent terminals are limited, performing reasonable resource allocation optimization can improve the performance, especially for a multi-terminals offloading system. In this study, to minimize the task computation delay, we jointly optimize the local content splitting ratio, the transmission/computation power allocation, and the MEC server selection under a dynamic environment with stochastic task arrivals. The challenging dynamic joint optimization problem is formulated as a reinforcement learning (RL) problem, which is designed as the computational offloading policies to minimize the long-term average delay cost. Two deep RL strategies, deep Q-learning network (DQN) and deep deterministic policy gradient (DDPG), are adopted to learn the computational offloading policies adaptively and efficiently. The proposed DQN strategy takes the MEC selection as a unique action while using the convex optimization approach to obtain the local content splitting ratio and the transmission/computation power allocation. Simultaneously, the actions of the DDPG strategy are selected as all dynamic variables, including the local content splitting ratio, the transmission/computation power allocation, and the MEC server selection. Numerical results demonstrate that both proposed strategies perform better than the traditional non-learning schemes. The DDPG strategy outperforms the DQN strategy in all simulation cases exhibiting minimal task computation delay due to its ability to learn all variables online.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.