No abstract

MFI-type zeolitic membranes were prepared on the porous α-A 2 O 3 support to investigate the separation properties of dichlorobenzene isomers. The pervaporation tests were performed with unary and binary isomer mixtures at 333 K. The results indicate that the silicalite membranes, irrespective of being synthesized by the templated or template-free method, are permeable for all dichlorobenzene isomers. The pervaporation fluxes of the pure dichlorobenzene isomers decrease in the order p-DCB > o-DCB > m-DCB. For the binary pervaporation system, the dichlorobenzene fluxes are all less than those with a single component due to the binary interactions between DCB isomers and between the DCB isomer and the zeolite membrane. Comparatively, the template-free MFI-type zeolite exhibits higher selectivity for dichlorobenzene isomers due to less inter-crystalline gaps. The separation factors for p-/o-DCB and p-/m-DCB can reach 16.7 and 22.0, respectively.

Preparing biochar from tobacco stalks modified with Mg is a feasible way to utilize tobacco stalks as a resource. However, the capacity of phosphate removal of Mg-biochar is affected greatly with increasing pH. In the present work, biochar produced from the tobacco stalks was modified via Mg addition and eggshells during the preparation for improving the phosphate adsorption performance at higher pH. The results revealed that the theoretical maximum adsorption capacity of phosphate for the biochar increased from 110.62 to 272.37 mg P/g when the mass ratio of Mg to tobacco stalk increased from 0.12:1 to 0.48:1 (M-C). The adsorption capacity of the biochar with a mass ratio of 0.3:1 (M-C2) was more than 200 mg P/g in the pH range of 3 to 7 but with further increase of pH from 7 to 12 the capacity decreased from 205 to 135.2 mg P g−1. Addition of eggshells with the magnesium solution during the dipping process can effectively improve the capacity of the modified biochar for phosphate in the alkaline condition. When the mass ratio of eggshell to tobacco stalk was ≥0.25:1, the phosphate adsorption capacities of the biochar can reach above 200 mg P/g within a wide pH range of 3 to 12, and the maximum adsorption capacity can reach more than 270 mg P g−1 for the mass ratio of 1:1 (EM-C24). The characterization results demonstrated that Ca and Mg were loaded on the biochar. The high adsorption performance provides reference values for the utilization of tobacco stalks and eggshells.