Summary Increasing demand of electricity and severer concerns to environment call for green energy sources as well as efficient energy conversion systems. SCO2 power cycles integrated with concentrating solar power (CSP) are capable of enhancing the competitiveness of thermal solar electricity. This article makes a comprehensive review of supercritical CO2 power cycles integrated with CSP. A detailed comparison of four typical CSP technologies is conducted, and the cost challenge of currently CSP technologies is pointed out. The thermophysical properties of sCO2 and the corresponding two real gas effects are analyzed elaborately to express the features of sCO2 power cycles. An extensive review of sCO2 layouts relevant for CSP including 12 single layouts and 1 combined layout is implemented logically. Strengths and weaknesses of sCO2 power cycles over traditional steam‐Rankine cycle generally adopted in current CSP plants are concluded, followed by metal material degration summary in CSP relevant temperature sCO2 environment, which shows that the nickel‐based alloy is a proper structural material candidate for sCO2‐CSP integration. Thermodynamic analyses of sCO2 power cycles when integrated with CSP are divided into three level of which design‐point analysis and off‐design modeling are conducted and compared, more researches into the off‐design point analysis, dynamic modeling, especially the transient behavior are suggested. Economic analysis of the integrated system is concluded and presents a considerable levelized cost of electricity reduction of 15.6% to 67.7% compared to that of state of art CSP. Taking the thermodynamic and economic analysis into consideration, target designs of sCO2 power cycles for CSP are summarized in three aspects. Finally, current theoretical and experimental researches of sCO2 power cycles integrated with CSP for market penetration are introduced. The strengths, weaknesses, and potential solutions to the gaps of three potential pathways (molten salt pathway, particle pathway, and gas phase pathway) to realize the integration of sCO2 power cycles in the next CSP generation plants up to 700°C are reviewed. In general, the integration of sCO2 power cycles with CSP technologies exhibits promising expectations for facilitating the competitiveness of thermal solar electricity.

Moving packed bed particle/supercritical carbon dioxide (SCO 2 ) heat exchanger (MPBE) is a critical equipment to integrate particle thermal energy storage technology with SCO 2 power cycle block in the next-generation concentrated solar power plants. A predictive heat transfer model for designing and evaluation of shell and plate particle/SCO 2 moving packed bed heat

No abstract

The sudden closure of the refueling valve during the refueling process will cause the water hammer phenomenon in the pipeline of the large aircraft fuel system and produce pressure waves propagating along the pipeline. In serious cases, it will cause severe damage to the pipeline. The pressure surge in the pipeline can be affected by many design factors. In this study, the numerical modeling method of the large aircraft fuel system is studied using the Flowmaster program, and the accuracy of steady and transient state analysis of the simulation method is verified by experimental data. Based on this numerical method, a complete system-level simulation model of the large aircraft fuel system was established. Using this model, the effects of valve closure speed, diameter of the refueling main pipe, and refueling volume flow rate on pipeline pressure surge during the refueling process are investigated. The results indicate that all three factors have a significant impact on the pipeline pressure surge of the fuel system. The effect of the valve closing speed and the pipe diameter on the pressure surge of the pipeline is nonlinear and gradually weakened with the decrease of valve speed and the increase of pipe diameter, while the effect of refueling volume flow rate on the pipeline pressure surge is approximately linear.

No abstract