Lignocellulosic biomass is an abundant and renewable resource for the production of biobased value‐added fuels, chemicals, and materials, but its effective exploitation by an energy‐efficient and environmentally friendly strategy remains a challenge. Herein, a facile approach for efficiently cleaving lignin–carbohydrate complexes and ultrafast fractionation of components from wood by microwave‐assisted treatment with deep eutectic solvent is reported. The solvent was composed of sustainable choline chloride and oxalic acid dihydrate, and showed a hydrogen‐bond acidity of 1.31. Efficient fractionation of lignocellulose with the solvent was realized by heating at 80 °C under 800 W microwave irradiation for 3 min. The extracted lignin showed a low molecular weight of 913, a low polydispersity of 1.25, and consisted of lignin oligomers with high purity (ca. 96 %), and thus shows potential in downstream production of aromatic chemicals. The other dissolved matter mainly comprised glucose, xylose, and hydroxymethylfurfural. The undissolved material was cellulose with crystal I structure and a crystallinity of approximately 75 %, which can be used for fabricating nanocellulose. Therefore, this work promotes an ultrafast lignin‐first biorefinery approach while simultaneously keeping the undissolved cellulose available for further utilization. This work is expected to contribute to improving the economics of overall biorefining of lignocellulosic biomass.

Cellulose nanocrystals (CNCs) were successfully extracted from wood flour by a two-step process that comprised ethanol and peroxide solvothermal pretreatment and an ultrasonic disintegration process.

No abstract

No abstract

No abstract

Improving the flame retardancy of wood is an imperative yet highly challenging step in the application of wood in densely populated spaces. In this study, Mg-Al-layered double-hydroxide (LDH) coating was successfully fabricated on a wood substrate to confer flame-retardant and smoke-suppression properties. The chemical compositions and bonding states characterized by energy-dispersive X-ray spectroscopy and X-ray photoelectron spectroscopy confirmed the coating constituents of Mg-Al LDH. The coating evenly covered the sample wood surfaces and provided both mechanical enhancement and flame-retardancy effects. The limiting oxygen index of the Mg-Al LDH-coated wood increased to 39.1% from 18.9% in the untreated wood. CONE calorimetry testing revealed a 58% reduction in total smoke production and a 41% reduction in maximum smoke production ratio in the Mg-Al LDH-coated wood compared to the untreated wood; the peak heat release rate and total heat release were also reduced by 49% and 40%, respectively. The Mg-Al LDH coating is essentially hydrophilic, but simple surface modification by fluoroalkyl silane could make it superhydrophobic, with a water contact angle of 152° and a sliding angle of 8.6°. The results of this study altogether suggest that Mg-Al LDH coating is a feasible and highly effective approach to nanoconstructing wood materials with favorable flame-retardant and smoke-suppression properties.

No abstract

No abstract