We developed a cross-layer design which combines adaptive modulation and coding at the physical layer with a truncated automatic repeat request protocol at the data link layer, in order to maximize spectral efficiency under prescribed delay and error performance constraints. We derive the achieved spectral efficiency in closed-form for transmissions over Nakagami-block fading channels. Numerical results reveal that retransmissions at the data link layer relieve stringent error control requirements at the physical layer, and thereby enable considerable spectral efficiency gain. This gain is comparable with that offered by diversity, provided that the maximum number of transmissions per packet equals the diversity order. Diminishing returns on spectral efficiency, that result when increasing the maximum number of retransmissions, suggest that a small number of retransmissions offers a desirable delay-throughput tradeoff, in practice. Index Terms-Adaptive modulation and coding (AMC), automatic repeat request (ARQ) protocol, cross-layer design, quality of service (QoS), wireless networks. His research interests include the areas of com-munications, signal processing, and networking, with emphasis on cross-layer analysis and design, quality of service support for multimedia applications over wired-wireless networks, and resource allocation.Shengli Zhou (M'03) received the B.S. and M.Sc. degrees in electrical engineering and information science from the University

No abstract

Wireless power transfer (WPT) is a promising solution to provide convenient and perpetual energy supplies to electronics. Traditional WPT technologies face the challenge of providing Watt-level power over meter-level distance for Internet of Things (IoT) and mobile devices, such as sensors, controllers, smart-phones, laptops, etc.. Distributed laser charging (DLC), a new WPT alternative, has the potential to solve these problems and enable WPT with the similar experience as WiFi communications. In this paper, we present a multi-module DLC system model, in order to illustrate its physical fundamentals and mathematical formula. This analytical modeling enables the evaluation of power conversion or transmission for each individual module, considering the impacts of laser wavelength, transmission attenuation and photovoltaic-cell (PV-cell) temperature. Based on the linear approximation of electricity-to-laser and laser-to-electricity power conversion validated by measurement and simulation, we derive the maximum power transmission efficiency in closed-form. Thus, we demonstrate the variation of the maximum power transmission efficiency depending on the supply power at the transmitter, laser wavelength, transmission distance, and PV-cell temperature. Similar to the maximization of information transmission capacity in wireless information transfer (WIT), the maximization of the power transmission efficiency is equally important in WPT. Therefore, this work not only provides the insight of DLC in theory, but also offers the guideline of DLC system design in practice.

No abstract

No abstract

For a distributed fiber-optic vibration sensor (DFVS), the vibration signal extracted from the phase of backscattering has a linear response to the applied vibration, and is more attractive than that from the intensity term. However, the large phase noise at a random weak-fading-point seriously limits the sensor's credibility. In this paper, a novel phase-detection DFVS is developed, which effectively eliminates the weak-fading-point. The relationship between phase noise and the intensity of backscattering is analyzed, and the inner-pulse frequency-division method and rotated-vector-sum method are introduced to effectively suppress phase noise. In experiments, two simultaneous vibrations along the 35-kilometer-long fiber are clearly detected by phase detection with the signal-to-noise ratio (SNR) over 26 dB. The spatial resolution approaches 5 m and the vibration response bandwidth is 1.25 kHz.

No abstract

No abstract