Ternary organic solar cells enjoy both the enhanced light absorption by incorporating multiple organic materials in tandem solar cells and the simplicity of processing conditions that are used in single bulk heterojunction solar cells.

In this work, an effectual strategy of constructing polar small molecule acceptors (SMAs) to promote fill factor (FF) of nonfullerene polymer solar cells (PSCs) is first reported. Three asymmetrical SMAs of IDT6CN, IDT6CN-Th, and IDT6CN-M, which own large dipole moments, are designed and synthesized. The PSCs based on three polar SMAs exhibit apparently higher FFs compared with their symmetrical analogues. The asymmetrical design strategy accompanied with side chain and end group engineering makes IDT6CN-Th- and IDT6CN-M-based nonfullerene PSCs achieve high power conversion efficiency with FFs approaching 77%.

No abstract

We report a trap-assisted photomultiplication (PM) phenomenon in solution-processed polymer photodetectors (PPDs) based on P3HT:PC71BM as the active layer, the maximum EQE of 16,700% is obtained for the PPDs with PC71BM doping weight ratio of 1%. The PM phenomenon is attributed to the enhanced hole tunneling injection assisted by trapped electrons in PC71BM near Al cathode, which can be demonstrated by the transient photocurrent curves and EQE spectra of PPDs with different PC71BM doping ratios. The positive effect of trapped electrons in PC71BM near Al cathode on the hole tunneling injection is further confirmed by the simulated optical field and exciton generation rate distributions in the active layer and the EQE spectra of PPDs with Al(1)/P3HT:PC71BM(100:1)/Al(2) device structure under forward and reverse biases. This discovery may open a new road for organic materials to be used in highly sensitive photodetectors while preserving the advantages of organic materials.

The alloy acceptor (indene-C bis-adduct (ICBA)/[6,6]-phenyl-C -butyric acid-methyl-ester (PC BM)) is employed to replace the widely used fullerene acceptor (PC BM) in organic solar cells based on five different polymer donors, which exhibit a higher efficiency and much better device stability than the PC BM counterpart.

Obtaining both high open-circuit voltage (Voc) and short-circuit current density (Jsc) has been a major challenge for efficient all-polymer solar cells (all-PSCs). Herein, we developed a polymer acceptor PF5-Y5 with...

A smart strategy is reported to obtain photomultiplication (PM) type polymer photodetectors (PPDs) based on poly(3-hexylthiophene) (P3HT) and [6,6]-phenyl-C61-butyric acid methyl ester (PC61BM) which are commonly used in polymer solar cells. The PPDs with 1 wt % PC61BM exhibit a champion EQE of 37,500% under 625 nm illumination with an intensity of 8.87 μW cm(-2) at -19 V bias. The PM phenomenon of PPDs with rather low PC61BM doping ratios should be attributed to the enhanced hole tunneling injection assisted by trapped electrons in PC61BM near the Al cathode, which can be completely demonstrated from (i) turning distribution of electron traps by changing P3HT:PC61BM doping weight ratios from 200:1 to 1:1; (ii) adjusting interfacial barrier width by inserting LiF layer between the active layer and the Al cathode.

No abstract