© 2017 IEEE. High-Tc superconducting (HTS)-coated conductors are a promising option for the next-generation power devices. However, their thin-film geometry incurs dynamic loss when exposed to a perpendicular external ac magnetic field, which is difficult to predicate and estimate. In this paper, we propose and verify a numerical simulation model to predict the dynamic loss in HTS-thin-coated conductors by taking into account their Jc-B dependence and I-V characteristics. The model has been tested on a SuperPower YBCO-coated conductor, and we observed a linear increase of dynamic loss along the increasing field amplitude after the threshold field. Our simulation results agree closely with experimental measurements as well as an analytical model. Furthermore, the model can predict the nonlinear increase of dynamic loss at high current, while the analytical model deviates from the measurement results and still shows a linear correlation between the dynamic loss and the external magnetic field. In addition, we have used this model to simulate the distributions of magnetic field and current density when dynamic loss occurs. Results clearly show the flux traversing the coated conductor, which causes dynamic loss. These distributions have also been used to analyze the change of dynamic loss when either the transport current or the magnetic field increase individually, while the other factor remains constant. The simulation analysis on dynamic loss is done for the first time in this paper, and our results clearly demonstrate how dynamic loss changes as well as its dependence on transport current and magnetic field. © 2018 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other uses, in any current or future media, including reprinting/republishing this material for advertising or promotional purposes, creating new collective works, for resale or redistribution to servers or lists, or reuse of any copyrighted component of this work in other works.
Dynamic resistance, which occurs when a HTS coated conductor carries a DC current under an AC magnetic field, can have critical implications for the design of HTS machines. Here, we report measurements of dynamic resistance in a commercially available SuperPower 4 mm-wide YBCO coated conductor, carrying a DC current under an applied AC magnetic field of arbitrary orientation. The reduced DC current, I t/I c0, ranged from 0.01 to 0.9, where I t is the DC current level and I c0 is the self-field critical current of the conductor. The field angle (the angle between the magnetic field and the normal vector of the conductor wide-face) was varied between 0° and 90° at intervals of 10°. We show that the effective width of the conductor under study is ∼12% less than the physical wire width, and we attribute this difference to edge damage of the wire during or after manufacture. We then examine the measured dynamic resistance of this wire under perpendicular applied fields at very low DC current levels. In this regime we find that the threshold field, B th, of the conductor is well described by the nonlinear equation of Mikitik and Brandt. However, this model consistently underestimates the threshold field at higher current levels. As such, the dynamic resistance in a coated conductor under perpendicular magnetic fields is best described using two different equations for each of the low and high DC current regimes, respectively. At low DC currents where I t/I c0 ≤ 0.1, the nonlinear relationship of Mikitik and Brandt provides the closest agreement with experimental data. However, in the higher current regime where I t/I c0 ≥ 0.2, closer agreement is obtained using a simple linear expression which assumes a current-independent penetration field. We further show that for the conductor studied here, the measured dynamic resistance at different field angles is dominated by the perpendicular magnetic field component, with negligible contribution from the parallel component. Our findings now enable the dynamic resistance of a single conductor to be analytically determined for a very wide range of DC currents and at all applied field angles. This is the Accepted Manuscript version of an article accepted for publication in 'Superconductor Science and Technology'. IOP Publishing Ltd is not responsible for any errors or omissions in this version of the manuscript or any version derived from it. The Version of Record is available online at https://doi.org/10.1088/1361-6668/aaa49e.
Dynamic resistance, which occurs when a HTS coated conductor carries a DC current under an AC magnetic field, can have critical implications for the design of HTS machines. Here, we report measurements of dynamic resistance in a commercially available SuperPower 4 mm-wide YBCO coated conductor, carrying a DC current under an applied AC magnetic field of arbitrary orientation. The reduced DC current, I t/I c0, ranged from 0.01 to 0.9, where I t is the DC current level and I c0 is the self-field critical current of the conductor. The field angle (the angle between the magnetic field and the normal vector of the conductor wide-face) was varied between 0° and 90° at intervals of 10°. We show that the effective width of the conductor under study is ∼12% less than the physical wire width, and we attribute this difference to edge damage of the wire during or after manufacture. We then examine the measured dynamic resistance of this wire under perpendicular applied fields at very low DC current levels. In this regime we find that the threshold field, B th, of the conductor is well described by the nonlinear equation of Mikitik and Brandt. However, this model consistently underestimates the threshold field at higher current levels. As such, the dynamic resistance in a coated conductor under perpendicular magnetic fields is best described using two different equations for each of the low and high DC current regimes, respectively. At low DC currents where I t/I c0 ≤ 0.1, the nonlinear relationship of Mikitik and Brandt provides the closest agreement with experimental data. However, in the higher current regime where I t/I c0 ≥ 0.2, closer agreement is obtained using a simple linear expression which assumes a current-independent penetration field. We further show that for the conductor studied here, the measured dynamic resistance at different field angles is dominated by the perpendicular magnetic field component, with negligible contribution from the parallel component. Our findings now enable the dynamic resistance of a single conductor to be analytically determined for a very wide range of DC currents and at all applied field angles. This is the Accepted Manuscript version of an article accepted for publication in 'Superconductor Science and Technology'. IOP Publishing Ltd is not responsible for any errors or omissions in this version of the manuscript or any version derived from it. The Version of Record is available online at https://doi.org/10.1088/1361-6668/aaa49e.
© 2017 IEEE. High-Tc superconducting (HTS)-coated conductors are a promising option for the next-generation power devices. However, their thin-film geometry incurs dynamic loss when exposed to a perpendicular external ac magnetic field, which is difficult to predicate and estimate. In this paper, we propose and verify a numerical simulation model to predict the dynamic loss in HTS-thin-coated conductors by taking into account their Jc-B dependence and I-V characteristics. The model has been tested on a SuperPower YBCO-coated conductor, and we observed a linear increase of dynamic loss along the increasing field amplitude after the threshold field. Our simulation results agree closely with experimental measurements as well as an analytical model. Furthermore, the model can predict the nonlinear increase of dynamic loss at high current, while the analytical model deviates from the measurement results and still shows a linear correlation between the dynamic loss and the external magnetic field. In addition, we have used this model to simulate the distributions of magnetic field and current density when dynamic loss occurs. Results clearly show the flux traversing the coated conductor, which causes dynamic loss. These distributions have also been used to analyze the change of dynamic loss when either the transport current or the magnetic field increase individually, while the other factor remains constant. The simulation analysis on dynamic loss is done for the first time in this paper, and our results clearly demonstrate how dynamic loss changes as well as its dependence on transport current and magnetic field. © 2018 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other uses, in any current or future media, including reprinting/republishing this material for advertising or promotional purposes, creating new collective works, for resale or redistribution to servers or lists, or reuse of any copyrighted component of this work in other works.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.