Titanium (Ti-6Al-4V) is an α+β phase-field alloy utilized in many industries due to its high strength-to-weight ratio and near-net shaping capability. Solution treated & aging, and stress relief annealing processes were performed on the samples to increase the strength and % of elongation. The heat-treated samples then thermally cycled for 500 cycles, 1000 cycles, and 1500 cycles to evaluate the microhardness and tensile properties. The presence of martensite and α2 precipitates in the thermally cycled samples was confirmed by scanning electron microscopy (SEM) and X-ray diffraction analysis (XRD). In this investigation, at 1000 thermal cycles, all specimens show improvement in both hardness and strength when compared within the cycles. Solution-treated and aging (STA), stress relief annealing (SRA), and without any heat-treatment (WHT) processes have their highest hardness values recorded for 1000 thermal cycles, and the values are 471 HV0.5, 381 HV0.5, and 374.6HV0.5, respectively. For the SRA process, ultimate tensile strength (UTS) of 925 MPa and yield strength (YS) of 896 MPa have resulted in 1000 cycles. Similarly, at 1000 thermal cycle WHT processed samples yielded UTS of 920 MPa and YS of 885 MPa. STA process samples that are heat-treated for 1000 thermal cycles have better strength properties than SRA and WHT and had a UTS of 1530MPa and YS of 1420MPa. From a ductility point of view, a maximum elongation of 29% for the STA process has resulted. Compared to forged titanium alloy (base metal), an increase of 31% elongation and 41% ultimate tensile strength for solution treated and aging process at 1000 cycles has resulted in this investigation.

No abstract

Particle board serves numerous functions such as cabinetry, tabletops, shelving, wall & floor panels, etc. Though Particle boards are much cheaper compared to solid wood, machining the material by optimizing the process parameters is a big challenge. Drilling is the major operation during final assembly of particle board, where fasteners are used to join together to bring final shape to the product. In this paper, the operation parameters such as speed, feed, drill diameter has been considered during drilling operation performed on Particle board and the output responses-surface roughness of the drilled hole and the Thrust force acting on the board during drilling are measured. Good surface finish of the hole ensures reduction of localised stresses around the hole due to fastening. Reduced Thrust force contributes to lesser delamination in particle board. Hence minimisation of both surface roughness and delamination is desired and hence optimisation of both responses is done simultaneously using grey relational analysis.

No abstract

No abstract