In this study, molecular dynamics (MD) simulations coupled with multi-scale shock technique (MSST) are used to predict the Hugoniot curve PH, Grüneisen coefficient γ and melting temperature Tm of single crystal (SC) and nanocrystalline (NC) aluminum (Al) with grain sizes of 6 and 60 nm at dynamic high pressure. The linear relation between the shock wave velocity and particle velocity is reproduced, and the results indicate that there is nearly no difference for the Hugoniot of SC and NC Al, which could be explained by the fact that the grain size effect on PH can be negligible at high pressure. Some empirical models are used to predict γ and Tm, which exhibit an opposite behavior. In addition, it is found that the melting pressure and temperature are 107.5 GPa, 3063 K for SC Al, while they are 109.5 GPa, 3082 K for NC Al, which have a reasonable agreement with the published work.

No abstract

No abstract

No abstract

In order to study the dynamic crack propagation law in fissured rock under the different fillings, a borehole with 7 mm diameter was processed in the center of a polymethyl methacrylate (PMMA) specimen. The preexisting fissure with different angles (θ = 0°, 45°, and 90°) and different distances (L = 20, 30, 40, 50, and 60 mm) was prefabricated around the borehole. Air, soil, and water were employed as fillings in the fissure, respectively. The experiment of explosive loading was carried out by a single detonator, and the dynamic crack propagation process of the experimental specimens was simulated by nonlinear dynamics software AUTODYN. The results show that the blast-induced cracks are the most favorable and unfavorable to propagate when θ = 0° and θ = 45°, respectively. The length of the far-end wing crack decreases with the increase of the distance L, and the length of the far-end wing crack in the air-filled specimens is larger than those in soil-filled and water-filled specimens. The damage-pressure curve of the far-end wing crack initiation point shows “S”-type change, and the damage-pressure curve shows two obvious damage evolution processes of initial nonlinear and later linear stages. With the increase of the angle, the distance from the borehole to the crack initiation point decreases and the compressive stress wave peak value should increase, but the tensile force peak value decreases. Meanwhile, the relationships between pressure and average velocity of the initiation point and L, θ, and fillings are established, respectively. The numerical simulation agrees with the experimental results well. It can be seen that the fillings types, angle, and distance have a mutual restraint relationship with the reflected and absorbed stress wave energy. The phenomenon of crack propagation under different fillings can be explained well from the viewpoint of discontinuity degree and stress wave energy, which reveals the general law of blast-induced crack propagation.