The replacement of fossil fuel with renewable energy sources seems as though it will be crucial in the future. On the other hand, waste generation increases year by year. Thus, waste-to-energy technologies fit in with the actual trends, such as the circular economy. The crucial type of generated waste is municipal solid waste, which is in the research area. Regarding the organic fraction of municipal solid waste (OFMSW), anaerobic digestion (AD) allows the recovery of biogas and energy. Furthermore, if it is supported by source segregation, it should allow the recovery of material as fertilizer. The AD process performance (biogas yield and stability) comparison of source-segregated OFMSW (ss-OFMWS) and mechanically sorted OFMSW (ms-OFMSW) as feedstocks was performed in full-scale conditions. The daily biogas volume and methane content were measured to assess AD efficiency. To verify the process stability, the volatile fatty acid (VFA) content, pH value, acidity, alkalinity, and dry matter were determined. The obtained biogas yield per ton was slightly higher in the case of ss-OFMSW (111.1 m3/ton), compared to ms-OFMSW (105.3 m3/ton), together with a higher methane concentration: 58–60% and 51–53%, respectively, and followed by a higher electricity production capacity of almost 700 MWh for ss-OFMSW digestion. The obtained VFA concentrations, at levels around 1.1 g/kg, pH values (slightly above 8.0), acidity, and alkalinity indicate the possibilities of the digester feeding and no-risk exploitation of either as feedstock.

Steady consumption of beer results in a steady output of residues, i.e., brewer's spent grain (BSG). Its valorization, using hydrothermal carbonization (HTC) seems sensible. However, a significant knowledge gap regarding the variability of this residue and its influence on the valorization process and its potential use in biorefineries exists. This study attempted to fill this gap by characterization of BSG in conjunction with the main product (beer), taking into accounts details of the brewing process. Moreover, different methods to assess the performance of HTC were investigated. Overall, the differences in terms of the fuel properties of both types of spent grain were much less stark, in comparison to the differences between the respective beers. The use of HTC as a pretreatment of BSG for subsequent use as a biorefinery feedstock can be considered beneficial. HTC was helpful in uniformization and improvement of the fuel properties. A significant decrease in the oxygen content and O/C ratio and improved grindability was achieved. The Weber method proved to be feasible for HTC productivity assessment for commercial installations, giving satisfactory results for most of the cases, contrary to traditional ash tracer method, which resulted in significant overestimations of the mass yield.However, for craft breweries located in big cities, disposal becomes more problematic [3]. There are also attempts to enrich food products with spent grains. Thus far, there have been trials with sausages [4] and bread [5]. However, consumers reported that such products represent a fiber aftertaste [6]. However, this is limited only to the relatively close vicinity of a brewery, due to relatively high moisture content, that could range between 70% up to 78% 70% [7][8][9]. Biological activity of these residues makes long term storage difficult. The literature reports ongoing work on various new ways of using BSG, including extraction of polyphenols [10,11], other anti-oxidants [12,13], functional cardioprotective lipids for pharmaceutic use [14], proteins [15], fodder for edible insects [16], material for disposable trays [17], natural rubber modifier [18], as well as feedstock for production of pigments [19] and biochar, for subsequent use as soil amendment [20] or sustainable material for electrodes [21].The potential use of this residue as a fuel has been suggested by several authors so far [7][8][9]22,23]. The relatively high initial moisture content of spent grain makes hydrothermal valorization techniques the most sensible choice [8,9]. Hydrothermal carbonization (HTC), also known as wet torrefaction, is a valorization process suitable for a range of low-quality solid biomass, especially with high initial moisture content [24,25]. Process temperature, reported in the literature, usually ranges between 180 • C and 260 • C [25][26][27][28][29][30]. As the process takes place in subcritical water, pressure has to be higher than saturation pressure of water for specific temperature [25][26][27][28][29][30]. In these conditions wa...

Due to various ecological problems, it is required to remove the ammonia nitrogen from wastewater. Industrial wastewater that was not subjected to any purification was used in this study, while most processes described in the literature were carried out using synthetically prepared solutions. The study investigated the removal of ammonium ions using ion exchange on various commercial minerals, in 3 h long batch ion-exchange experiments. Furthermore, research on the sodium chloride activation of the selected mineral was conducted. The screening of the mineral with the highest removal potential was conducted taking into account the adsorption capacity (q) and maximal removal efficiency (E), based on the NH4+ ions changes determined using the selective electrode and spectrophotometric cuvette tests. The highest adsorption capacity (q = 4.92 mg/g) of ammonium ions with the maximum removal efficiency (52.3%) was obtained for bentonite, with a 0–0.05 mm particle size. After pretreatment with a 1 mol/L NaCl solution, maximum efficiency increments were observed (55.7%). The Langmuir adsorption isotherm corresponds well with the equilibrium adsorption data (R2 from 0.97 to 0.98), while the Freundlich model was found to be mismatched (R2 = 0.77). Based on these results it was concluded that natural sorbents may be effectively applied in wastewater treatment. It can be observed that as the size of sorbent particles gets lower, the adsorption capacity, as well as the removal efficiency, gets higher. The bentonite pretreatment with the NaCl solution did not result in the expected efficiency improvement. The 2 mol/L solution affected about 3.5% of the removal efficiency yield.

Agriculture affects both the quantity and the quality of water available for other purposes, which becomes problematic, especially during increasingly frequent severe droughts. This requires tapping into the resources that are typically neglected. One such resource is a by-product of anaerobic digestion, in which moisture content typically exceeds 90%. Application of hydrothermal carbonization process (HTC) to this residue could partially remove organic and inorganic material, improve dewatering, decrease the overall solid mass, sanitize the digestate, change its properties, and eliminate problems related with emissions of odors from the installation. However, a significant gap still exists in terms of the dewatering of the hydrochars and the composition of the effluents. This work presents results of experimental investigation focused on the removal of organic compounds from the HTC effluent. Results of qualitative and quantitative analysis of liquid by-products of HTC of the agricultural digestate showed that acetic acid, 3-pyridinol, 1-hydroxyacetone, and 1,3-propanediol were the main liquid organic products of the process. Application of ultrafiltration process with the use of 10 kDa membrane for liquid HTC by-product treatment allows for the reduction of chemical oxygen demand up to 30%, biological oxygen demand up to 10%, and dissolved organic carbon up to 21%.

Anaerobic digestion (AD) is a commonly used method of processing waste. Regardless of the type of the used digestate (fertilizer, feedstock in case of solid-state fermentation, raw-material in case of thermal treatment) effective pathogen risk elimination, even in the case of high pathogen concentration is essential. An investigation of the survival time and inactivation rate of the Salmonella Senftenberg W775, Enterococcus spp., and Ascaris suum eggs during thermophilic anaerobic digestion performed on laboratory scale and confirmation of hygienization in full-scale operation were performed in this study. Except for sanitization efficiency, the AD process performance and stability were also verified based on determination of pH value, dry matter content, acidity, alkalinity, and content of fatty acids. The elimination of pathogen was met within 6.06 h, 5.5 h, and about 10 h for the Salmonella Senftenberg W775, Enterococcus spp., and Ascaris suum, respectively in the laboratory trials. The obtained results were confirmed in full-scale tests, using 1500 m3 Kompogas® reactors, operating in MBT Plant located in Poland. Sanitization of the digestate was achieved. Furthermore, the process was stable. The pH value, suspended solids, and ammonium content remained stable at 8.5, 35%, and 3.8 g/kg, respectively. The acetic acid content was noted between almost 0.8 and over 1.1 g/kg, while the concentration of propionic acid was noted at maximum level of about 100 mg/kg. The AD conditions could positively affect the pathogen elimination. Based on these results it can be found that anaerobic digestion under thermophilic conditions results in high sanitation efficiency.