No abstract

To investigate the effects of expanding rubber (Hevea brasiliensis) cultivation on water cycling in Mainland Southeast Asia (MSEA), evapotranspiration (ET) was measured within rubber plantations at Bueng Kan, Thailand, and Kampong Cham, Cambodia. After energy closure adjustment, mean annual rubber ET was 1211 and 1459 mm yr 21 at the Thailand and Cambodia sites, respectively, higher than that of other tree-dominated land covers in the region, including tropical seasonal forest (812-1140 mm yr 21 ), and savanna (538-1060 mm yr 21 ). The mean proportion of net radiation used for ET by rubber (0.725) is similar to that of tropical rainforest (0.729) and much higher than that of tropical seasonal forest (0.595) and savanna (0.548). Plant area index (varies with leaf area changes), explains 88.2% and 73.1% of the variance in the ratio of latent energy flux (energy equivalent of ET) to potential latent energy flux (LE/LE pot ) for midday rain-free periods at the Thailand and Cambodia sites, respectively. High annual rubber ET results from high late dry season water use, associated with rapid refoliation by this brevideciduous species, facilitated by tapping of deep soil water, and by very high wet season ET, a characteristic of deciduous trees. Spatially, mean annual rubber ET increases strongly with increasing net radiation (R n ) across the three available rubber plantation observation sites, unlike nonrubber tropical ecosystems, which reduce canopy conductance at high R n sites. High water use by rubber raises concerns about potential effects of continued expansion of tree plantations on water and food security in MSEA.

The aim of this study was to assess the temperature response of photosynthesis in rubber trees (Hevea brasiliensis Müll. Arg.) to provide data for process-based growth modeling, and to test whether photosynthetic capacity and temperature response of photosynthesis acclimates to changes in ambient temperature. Net CO 2 assimilation rate (A) was measured in rubber saplings grown in a nursery or in growth chambers at 18 and 28°C. The temperature response of A was measured from 9 to 45°C and the data were fitted to an empirical model. Photosynthetic capacity (maximal carboxylation rate, V cmax , and maximal light driven electron flux, J max ) of plants acclimated to 18 and 28°C were estimated by fitting a biochemical photosynthesis model to the CO 2 response curves (A-C i curves) at six temperatures: 15, 22, 28, 32, 36 and 40°C. The optimal temperature for A (T opt ) was much lower in plants grown at 18°C compared to 28°C and nursery. Net CO 2 assimilation rate at optimal temperature (A opt ), V cmax and J max at a reference temperature of 25°C (V cmax25 and J max25 ) as well as activation energy of V cmax and J max (E aV and E aJ ) decreased in individuals acclimated to 18°C. The optimal temperature for V cmax and J max could not be clearly defined from our response curves, as they always were above 36°C and not far from 40°C. The ratio J max25 /V cmax25 was larger in plants acclimated to 18°C. Less nitrogen was present and photosynthetic nitrogen use efficiency (V cmax25 /N a ) was smaller in leaves acclimated to 18°C. These results indicate that rubber saplings acclimated their photosynthetic characteristics in response to growth temperature, and that higher temperatures resulted in an enhanced photosynthetic capacity in the leaves, as well as larger activation energy for photosynthesis.

Rubber tree (Hevea brasiliensis Müll. Arg.) radial growth dynamics were monitored with displacement sensors, together with latex production, to investigate three aspects of the dual production of latex and wood: (1) the usefulness of fine-scale dendrometric measurements as a physiological tool to detect water shortage through radial growth; (2) the dynamic aspects, both at the seasonal and at the multi-year scale, of the competition between latex and wood production; and (3) the spatial distribution of radial growth rates around the tapping cut. Radial growth of untapped control trees started with the onset of the rainy season and lasted until the onset of the dry season, ceasing completely during the driest period. Displacement sensors provided a sensitive means of detecting water shortage, with a clear correlation between diameter variations and changes in water availability (both daily evapotranspiration and monthly rainfall) over the whole annual cycle. However, the correlation was significantly disturbed in tapped trees. After resumption of tapping, the radial growth rate dropped sharply within two weeks and the effect persisted throughout the whole season, so that the cumulative growth of tapped trees was about half that of untapped trees, with the cumulative growth deficit reaching 80% for the period from mid-June to November. This long-known negative impact of tapping on growth was much stronger in the second year of tapping than in the first, whereas latex production increased significantly between the first and second year of tapping. The increased latex production, which could not be ascribed to climatic conditions, shows that the establishment of an artificial latex sink is a progressive, long-term process likely involving many aspects of metabolism. As expected, ethylene significantly increased latex production in both years; however, ethylene had no effect on the growth rates of tapped trees. Radial growth was differentially affected at different locations around the tapping cut, with growth rates significantly lower in the tapped panel than in the untapped panel, and higher above the cut than below the cut. Thus, caution is needed when deriving whole stem wood production from girth measurements at one location on the stem, especially from girth measurements made close to the tapping cut. This also provides new evidence for the location of the latex regeneration area in the tapped panel, below the cut.

When the current level of carbohydrates produced by photosynthesis is not enough to meet the C demand for maintenance, growth or metabolism, trees use stored carbohydrates. In rubber trees (Hevea brasiliensis Muell. Arg.), however, a previous study (Silpi U., A. Lacointe, P. Kasemsap, S. Thanisawanyangkura, P. Chantuma, E. Gohet, N. Musigamart, A. Clement, T. Améglio and P. Thaler. 2007. Carbohydrate reserves as a competing sink: evidence from tapping the rubber tree. Tree Physiol. 27:881-889) showed that the additional sink created by latex tapping results not in a decrease, but in an increase in the non-structural carbohydrate (NSC) storage in trunk wood. In this study, the response of NSC storage to latex tapping was further investigated to better understand the trade-off between latex regeneration, biomass and storage. Three tapping systems were compared to the untapped Control for 2 years. Soluble sugars and starch were analyzed in bark and wood on both sides of the trunk, from 50 to 200 cm from the ground. The results confirmed over the 2 years that tapped trees stored more NSC, mainly starch, than untapped Control. Moreover, a double cut alternative tapping system, which produced a higher latex yield than conventional systems, led to even higher NSC concentrations. In all tapped trees, the increase in storage occurred together with a reduction in trunk radial growth. This was interpreted as a shift in carbon allocation toward the creation of reserves, at the expense of growth, to cover the increased risk induced by tapping (repeated wounding and loss of C in latex). Starch was lower in bark than in wood, whereas it was the contrary for soluble sugars. The resulting NSC was twice as low and less variable in bark than in wood. Although latex regeneration occurs in the bark, changes related to latex tapping were more marked in wood than in bark. From seasonal dynamics and differences between the two sides of the trunk in response to tapping, we concluded that starch in wood behaved as the long-term reserve compartment at the whole trunk level, whereas starch in bark was a local buffer. Soluble sugars behaved like an intermediate, ready-to-use compartment in both wood and bark. Finally, the dynamics of carbohydrate reserves appears a relevant parameter to assess the long-term performance of latex tapping systems.