BackgroundHemicellulose extraction from lignocellulosic biomasses has gained interest over the years, and hydrothermal treatment is one of the most common methods employed for this purpose. This work aimed to deeply study hazelnut (Corylus avellana L.) shells as a new source of dietary fibre, evaluating the effect of hydrothermal treatment temperatures on the type and structure of fibre extracted, but also on the formation of side‐products derived from lignocellulose degradation.ResultsDifferent process temperatures led to diverse polysaccharides in the hydrothermal extract. Pectin was identified for the first time in hazelnut shells when experimenting with extraction at 125 °C, whereas at 150 °C a heterogeneous mixture of pectin, xylan, and xylo‐oligosaccharides was present. The highest yield in terms of total fibre was gained at 150 and 175 °C, and then decreased again at 200 °C. Finally, more than 500 compounds from different chemical classes were putatively identified and they appeared to be present in the extracted fibre with a different distribution and relative amount, depending on the heat treatment severity. A generally high content of phenols, phenyls, oligosaccharides, dehydro‐sugars, and furans was observed.ConclusionsModulation of the hydrothermal treatment temperature allows fibre extracts with very different compositions, and therefore different potential end uses, to be obtained from hazelnut shells. A sequential temperature‐based fractionation approach, as a function of the severity of the extraction parameters, can also be considered. Nevertheless, the study of the side‐compounds formed from lignocellulosic matrix degradation, as a function of the applied temperature, needs to be fully addressed for a safe introduction of the fibre extract within the food chain. © 2023 The Authors. Journal of The Science of Food and Agriculture published by John Wiley & Sons Ltd on behalf of Society of Chemical Industry.

By-products from the fruit supply chain, especially seeds/kernels, have shown great potential to be valorised, due to their high content of macronutrients, such as lipids, protein, and fibre. A mild enzymatic assisted extraction (EAE) involving the use of a protease was tested to evaluate the feasibility of a cascade approach to fractionate the main fruit by-products components. Protease from Bacillus licheniformis (the enzyme used in the AOAC 991.43 official method for dietary fibre quantification) was used, and besides protein, the conditions of hydrolysis (60 °C, neutral pH, overnight) allowed us to dissolve a portion of soluble fibres, which was then separated from the solubilized peptide fraction through ethanol precipitation. Good protein extraction yields, in the range 35–93%, were obtained. The soluble fibre extraction yield ranged from 1.6% to 71% depending on the by-product, suggesting its applicability only for certain substrates, and it was found to be negatively correlated with the molecular weight of the fibre. The monosaccharide composition of the soluble fibres extracted was also diverse. Galacturonic acid was present in a low amount, indicating that pectin was not efficiently extracted. However, a predominance of arabinose and galactose monomers was detected in many fractions, indicating the isolation of a fruit soluble fibre portion with potential similarity with arabinogalactans and gum arabic, opening up perspectives for technological applications. The residual solid pellet obtained after protease assisted extraction was found to be an excellent fibre-rich substrate, suitable for being subjected to more “hard” processing (e.g., sequential pectin and hemicellulose extraction) with the objective to derive other fractions with potential great added economic value.

No abstract