This paper presents the development of a polymer based microneedle patch for transdermal drug delivery application using plastic microinjection moulding. Design and analysis of the microneedle cavities and mould insert used in the injection moulding process were carried out using Computer-Aided Engineering (CAE) software. A mould insert with low surface roughness was fabricated using Micro Electrical Discharge Machining (μ-EDM). The injection moulding parameters including clamping force, temperature, injection pressure and velocity were characterized in order to obtain the optimum reproducibility. Solid truncated cone microneedles, made of biocompatible polymethyl methacrylate (PMMA), with a round tip radius of 50 μm and 500 μm in height have been realized by microinjection moulding process demonstrating the potential of a low cost, high production efficiency, and suitable for mass production. In addition, a mould insert of cylindrical microneedles fabricated using X-ray LIGA has been proposed.
In this work, a simple, facile growth approach for a vertically aligned ZnO thin film is fabricated and its application towards methane gas sensors is demonstrated. ZnO thin film was prepared by a combination of hydrothermal and sputtering methods. First, a ZnO seed layer was prepared on the substrate through a sputtering technique, then a ZnO nanorod was fabricated using a hydrothermal method. The surface morphology of the ZnO film was observed by scanning electron microscopy (SEM). A ZnO nanorod coated on the dense seed layer is clearly visible in the SEM image. The average size of the hexagonal-shaped ZnO rod was around 50 nm in diameter, with a thickness of about 1 mm. X-ray absorption near-edge structures (XANES) were recorded to characterize the structural properties of the prepared film. The obtained normalized Zn K-edge XANES of the film showed the characteristic features of ZnO, which agreed well with the standard ZnO sample. The measurement of Zn K-edge XANES was performed simultaneously with the sensing response. The results showed a good correlation between sensor response and ZnO structure under optimal conditions.
In this work, we study and compare the photo-induced conductivity of a two-dimensional electron gas (2DEG) at the bare surface of SrTiO3 (STO) and in the heterostructure of BiFeO3 (BFO) and STO, where BFO was deposited by radio frequency magnetron sputtering. The photo-induced conductance of the BFO/STO interface shows a large increase which is 20.62 times more than the sum of photo-induced conductance from each individual BFO thin film and STO crystal. Since this photo-induced conductance of the BFO/STO heterostructure can be adjusted to become higher and lower by applying an electric field to the top surface, we attribute this large increase to the strong photo-induced electrical polarization of BFO. With the two-point setup of positive bias and negative bias, the conductivity also exhibits diode-like behavior where the forward and backward resistances are different. This work provides methods to interplay between light irradiation, electric field, and conductivity in all-oxide electronics.
The gold nanoparticles (Au NPs) localized surface plasmon resonance (LSPR) based detection of prostate-specific antigen (PSA) biomarker was carried out in this work. Au NPs on Si and quartz substrates were synthesized by DC magnetron sputtering method followed by conventional annealing
protocol. The functionalization of antibody and PSA with Au NPs was evaluated using a simple drop-cost method. The SPR peak intensity was found to be proportional to the PSA concentration. The redshift in SPR peak position might be owing to the change in refractive index around the Au NPs
with the conjugation of antibody and further additional binding of specific PSA at different concentrations.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.