Lead halide perovskite materials have attracted significant attention in the context of photovoltaics and other optoelectronic applications, and recently, research efforts have been directed to nanostructured lead halide perovskites. Collodial nanocrystals (NCs) of cesium lead halides (CsPbX3, X = Cl, Br, I) exhibit bright photoluminescence, with emission tunable over the entire visible spectral region. However, previous studies on CsPbX3 NCs did not address key aspects of their chemistry and photophysics such as surface chemistry and quantitative light absorption. Here, we elaborate on the synthesis of CsPbBr3 NCs and their surface chemistry. In addition, the intrinsic absorption coefficient was determined experimentally by combining elemental analysis with accurate optical absorption measurements. (1)H solution nuclear magnetic resonance spectroscopy was used to characterize sample purity, elucidate the surface chemistry, and evaluate the influence of purification methods on the surface composition. We find that ligand binding to the NC surface is highly dynamic, and therefore, ligands are easily lost during the isolation and purification procedures. However, when a small amount of both oleic acid and oleylamine is added, the NCs can be purified, maintaining optical, colloidal, and material integrity. In addition, we find that a high amine content in the ligand shell increases the quantum yield due to the improved binding of the carboxylic acid.

Inductively coupled plasma mass spectrometry (ICP-MS) was combined with UV-vis absorption spectroscopy and transmission electron microscopy to determine the size, composition, and intrinsic absorption coefficient μ of 4 to 11 nm sized colloidal CsPbBr nanocrystals (NCs). The ICP-MS measurements demonstrate the nonstoichiometric nature of the NCs, with a systematic excess of lead for all samples studied. Rutherford backscattering measurements indicate that this enrichment in lead concurs with a relative increase in the bromide content. At high photon energies, μ is independent of the nanocrystal size. This allows the nanocrystal concentration in CsPbBr nanocolloids to be readily obtained by a combination of absorption spectroscopy and the CsPbBr sizing curve.

While the surface termination of quasi-spherical metal chalcogenide nanocrystals or quantum dots has been widely investigated, it remains unclear whether the ensuing surface chemistry models apply to similar nanocrystals with anisotropic shapes. In this work, we report on the surface-chemistry of 2D CdSe nanoplatelets, where we make use of an improved synthesis strategy that yields stable and aggregation free nanoplatelet suspensions with a photoluminescence quantum yield as high as 55%. We confirm that such nanoplatelets are enriched in Cd and, by means of 1 H nuclear magnetic resonance spectroscopy, we show that the Cd-rich surface is terminated by X-type carboxylate ligands. Not unlike CdSe quantum dots (QDs), entire cadmium carboxylate entities can be displaced by the addition of amines, and the desorption isotherm points toward a considerable binding site heterogeneity. Moreover, we find that even the slightest displacement of cadmium carboxylate ligands quenches the nanoplatelet photoluminescence. These experimental findings are further confirmed by density functional theory (DFT) calculations on a 5 monolayer model CdSe nanoplatelet. These simulations show that the most labile ligands are located in the vicinity of facet edges, and that the displacement of ligands from such edge sites creates midgap states that can account for the observed photoluminescence quenching. Next to extending surface chemistry insights from colloidal QDs to nanoplatelets, this work indicates that CdSe nanoplatelets constitute a unique nanocrystal model system to establish a comprehensive description of midgap trap states, which includes their structural, chemical, and electronic properties.

Colloidal quantum dots (QDs) raise more and more interest as solution-processable and tunable optical gain materials. However, especially for infrared active QDs, optical gain remains inefficient. Since stimulated emission involves multifold degenerate band-edge states, population inversion can be attained only at high pump power and must compete with efficient multi-exciton recombination. Here, we show that mercury telluride (HgTe) QDs exhibit size-tunable stimulated emission throughout the near-infrared telecom window at thresholds unmatched by any QD studied before. We attribute this unique behaviour to surface-localized states in the bandgap that turn HgTe QDs into 4-level systems. The resulting long-lived population inversion induces amplified spontaneous emission under continuous-wave optical pumping at power levels compatible with solar irradiation and direct current electrical pumping. These results introduce an alternative approach for low-threshold QD-based gain media based on intentional trap states that paves the way for solution-processed infrared QD lasers and amplifiers.

Ultrathin two-dimensional (2D) materials have received much attention in the past years for a wide variety of photonic applications because of their pronounced roomtemperature excitonic features, leading to unique properties in terms of light−matter interaction. However, only a few studies focus on light amplification and the complex photophysics at high excitation density. The beneficial nature of strong excitonic effects on optical gain remain hence unquantified, and despite the increased binding energies of the excitonic species, it remains unclear what the involvement of 2D excitons would be in optical gain. Here, we use colloidal CdSe nanoplatelets as a model system for colloidal 2D materials and show, using a quantitative and combinatory approach to ultrafast spectroscopy, that several excitation density-dependent optical gain regimes exist. At low density, optical gain originates from excitonic molecules delivering large material gains up to 20 000 cm −1 with an Auger limited lifetime of a few hundred picoseconds. At increasing pair density, we observe a persistence of this excitonic gain regime and the unexpected coexistence of blue-shifted and significantly enhanced optical gain up to 10 5 cm −1. We show that this peculiar situation originates from a carrier cooling bottleneck at high density that limits further exciton formation from unbound charge carriers. The insulating (multi-)exciton gas is found to coexist with the conductive phase, indicating the absence of a full Mott transition. Our results shed a new light on the photophysics of excitons in strongly excited 2D materials and pave the way for the development of more efficient (broadband) optical gain media and/or high exciton density applications.

We show that optical gain in 2D CdSe colloidal quantum wells (CQWs) shows little saturation and coexists with exciton absorption over a broad range of excitation densities, in stark contrast with 0D CdSe colloidal quantum dots (CQDs). In addition, we demonstrate that photoexcited CQWs can absorb or emit light through the thermodynamically driven formation or radiative recombination of singlet excitonic molecules. Invoking stimulated emission through the molecule−exciton transition, we can quantify all of the remarkable gain characteristics of CQWs using only experimentally determined parameters, an advance that highlights a fundamental difference between multiexcitons in CQWs and CQDs. While strong confinement prohibits the dissociation of multiexcitons into separate excitons in 0D CQDs, excitons and excitonic molecules coexist in a 2D CQW at room temperature, with densities governed by an association/ dissociation equilibrium, not by state-filling. Our finding points out future directions to optimize stimulated emission by excitonic 2D materials in general.

Colloidal core/shell InP/ZnSe quantum dots (QDs), recently produced using an improved synthesis method, have a great potential in life-science applications as well as in integrated quantum photonics and quantum information processing as single-photon emitters. Single-particle spectroscopy of 10 nm QDs with 3.2 nm cores reveals strong photon antibunching attributed to fast (70 ps) Auger recombination of multiple excitons. The QDs exhibit very good photostability under strong optical excitation. We demonstrate that the antibunching is preserved when the QDs are excited above the saturation intensity of the fundamental-exciton transition. This result paves the way toward their usage as high-purity on-demand single-photon emitters at room temperature. Unconventionally, despite the strong Auger blockade mechanism, InP/ZnSe QDs also display very little luminescence intermittency ("blinking"), with a simple on/off blinking pattern. The analysis of single-particle luminescence statistics places these InP/ZnSe QDs in the class of nearly blinking-free QDs, with emission stability comparable to state-of-the-art thick-shell and alloyed-interface CdSe/CdS, but with improved single-photon purity.

Colloidal quantum dots (QDs) are highly attractive as the active material for optical amplifiers and lasers. Here, we address the relation between the structure of CdSe/CdS core/shell QDs, the material gain they can deliver, and the threshold needed to attain net stimulated emission by optical pumping. On the basis of an initial gain model, we predict that reducing the thickness of the CdS shell grown around a given CdSe core will increase the maximal material gain, while increasing the shell thickness will lower the gain threshold. We assess this trade-off by means of transient absorption spectroscopy. Our results confirm that thin-shell QDs exhibit the highest material gain. In quantitative agreement with the model, core and shell sizes hugely impact on the material gain, which ranges from 2800 cm for large core/thin shell QDs to less than 250 cm for small core/thick shell QDs. On the other hand, the significant threshold reduction expected for thick-shell QDs is absent. We relate this discrepancy between model and experiment to a transition from attractive to repulsive exciton-exciton interactions with increasing shell thickness. The spectral blue-shift that comes with exciton-exciton repulsion leads to competition between stimulated emission and higher energy absorbing transitions, which raises the gain threshold. As a result, small-core/thick-shell QDs need up to 3.7 excitations per QD to reach transparency, whereas large-core/thin shell QDs only need 1.0, a number often seen as a hard limit for biexciton-mediated optical gain. This makes large-core/thin-shell QDs that feature attractive exciton-exciton interactions the overall champion core/shell configuration in view of highest material gain, lowest threshold exciton occupation, and longest gain lifetime.