No abstract

No abstract

Radial lip seals are successfully used since the 1940s to seal lubricated systems. Despite extensive experimental and theoretical research in the field, it is still not fully clear how these seals function. Experimental studies, found in the public literature, show that the relatively high surface roughness of the seal lip is very important for good and reliable performance. In addition, the pressure distribution under the lip seems to be a critical factor. Six fundamental hypotheses are presented on the lubrication, pumping, and sealing mechanisms to explain the working principles of these seals. It is generally accepted that lubrication results from microelastohydrodynamic film build up between the rough seal surface and the shaft. Non-symmetrical tangential deformations of the lip surface are observed during experiments and assumed to act like spiral groove bearings that generate a pumping action and lubricant film. Another hypothesis suggests that the lubricant will behave non-Newtonian under the very high shear rates experienced in operating conditions. This will reduce friction because of shear-thinning and enhances sealing. Macroscopic aids, like hydrodynamic pumping aids and engineered asperity patterns on the shaft, do improve seal performance. Almost all public literature discusses oil-lubricated radial lip seals while many seals are grease-lubricated, especially in certain technical fields. Due to the non-Newtonian behaviour of grease, the lubrication, sealing, and pumping mechanisms are assumed to differ from the oil-lubricated seals. Lower friction and improved protection against contamination are measured, and it is expected that the interest in grease lubrication will rapidly grow in future.

Grease is extensively used to lubricate various machine elements such as rolling bearings, seals, and gears. Understanding the flow dynamics of grease is relevant for the prediction of the grease distribution for optimum lubrication and the migration of wear-and contaminant particles. In this study grease flow is visualized using the method of micro Particle Image Velocimetry; the experimental setup comprises a concentric cylinder with rotating shaft to simulate the grease flow in a Double Restriction Seal (DRS) geometry with two different grease pocket heights. It is shown that grease may be partially yielded in the large grease pocket geometry and fully yielded in the small grease pocket geometry. For the small grease pocket geometry, it is shown that three distinct grease flow layers are present: a high shear rate region close to the stationary wall, a bulk flow layer, and a high shear rate boundary region near the rotating shaft. The grease shear thinning behaviour and its wall slip effects have been detected and discussed.