Two different laser phase noise measurement techniques are compared. One of these two techniques is based on a conventional and low-cost delay line system, which is usually set up for the linewidth measurement of semiconductor lasers. The results obtained with both techniques on a high-spectral-purity laser agree well and confirm the interest of the low-cost technique. Moreover, an extraction of the laser linewidth using computer-aided design tools is performed.

Optical Q factor measurements are performed on a whispering gallery mode (WGM) disk resonator using a microwave frequency domain approach instead of using an optical domain approach. An absence of hysteretic behavior and a better linearity are obtained when performing linewidth measurements by using a microwave modulation for scanning the resonances instead of the piezoelectric-based frequency tuning capability of the laser. The WGM resonator is then used to stabilize a microwave optoelectronic oscillator. The microwave output of this system generates a 12.48 GHz signal with -94 dBc/Hz phase noise at 10 kHz offset.