Phase-pure FeP nanoparticles have been synthesized by the reaction of iron(III) acetylacetonate with tris(trimethylsilyl)phosphine at temperatures of 240-320 °C using trioctylphosphine oxide as a solvent and dodecylamine (DA), myristic acid (MA), or hexylphosphonic acid (HPA) as additional capping groups (ligands). The DA-capped particles prepared at 260 °C have an average diameter of 4.65 ( 0.74 nm with FeP being the only observed crystalline phase. Elemental analyses indicate a high percentage yield of FeP (85%) and are consistent with 12% TOPO incorporation in the product. The addition of MA has results similar to those of the addition of DA, whereas addition of HPA seems to inhibit crystallite growth, resulting in very small (ca. 1 nm) or amorphous particles that are difficult to isolate. Magnetic susceptibility data on DA-capped FeP suggest that the moments within each particle are coupled antiferromagnetically, at least over a short range; however, there is no evidence of a Ne ´el transition, in contrast to bulk FeP. It is likely that the FeP particles produced by this route are too small (ca. 5 nm) relative to the magnetic cell (2.9 nm) for the onset of long-range helical antiferromagnetic order, even at low temperatures (5 K) and fields (0.010 T).

In this numerical study, a new type of serpentine micromixer involving mixing units with a non-rectangular cross-section is investigated. Similar to other serpentine/spiral shaped micromixers, the design exploits the formation of transversal vortices (Dean flows) in pressure-driven systems, associated with the centrifugal forces experienced by the fluid as it is confined to move along curved geometries. In contrast with other previous designs, though, the use of non-rectangular cross-sections that change orientation between mixing units is exploited to control the center of rotation of the transversal flows formed. The associated extensional flows that thus develop between the mixing segments complement the existent rotational flows, leading to a more complex fluid motion. The fluid flow characteristics and associated mixing are determined numerically from computational solutions to Navier–Stokes equations and the concentration-diffusion equation. It is found that the performance of the investigated mixers exceeds that of simple serpentine channels with a more consistent behavior at low and high Reynolds numbers. An analysis of the mixing quality using an entropic mixing index indicates that maximum mixing can be achieved at Reynolds numbers as small as 20 in less than four serpentine mixing units.

Co 1−x Fe x alloy nanowires with 40 nm diam and x=0–1.0 were fabricated by electrodeposition in nanopores of alumina templates. The crystalline structure of the nanowires is concentration dependent and shows a transition from the cobalt hexagonal-closed-packed structure (hcp) to a face-centered-cubic structure (fcc) in the concentration range 0<x<0.1. For an iron content greater than 15 at % the structure becomes body-centered-cubic (bcc). The nanowires with an aspect ratio of about 8 show a highly anisotropic magnetization with the easy axis along the length of the wire. The squareness of the hysteresis loops is between 72% and 93% for magnetic fields parallel to the wires while the squareness is less than 13% for fields perpendicular to the wires. The coercivity along the easy axis reaches a maximum of 2150 Oe for x=0.55 and is almost concentration independent for 0.5<x<0.6.

No abstract

Despite advances in the development of complex culture technologies, the utility, survival, and function of large 3D cell aggregates, or spheroids, are impeded by mass transport limitations. The incorporation of engineered microparticles into these cell aggregates offers a promising approach to increase spheroid integrity through the creation of extracellular spaces to improve mass transport. In this study, we describe the formation of uniform oxygenating fluorinated methacrylamide chitosan (MACF) microparticles via a T-shaped microfluidic device, which when incorporated into spheroids increased extracellular spacing and enhanced oxygen transport via perfluorocarbon substitutions. The addition of MACF microparticles into large liver cell spheroids supported the formation of stable and large spheroids (>500 μm in diameter) made of a heterogeneous population of immortalized human hepatoma (HepG2) and hepatic stellate cells (HSCs) (4 HepG2/1 HSC), especially at a 150:1 ratio of cells to microparticles. Further, as confirmed by the albumin, urea, and CYP3A4 secretion amounts into the culture media, biological functionality was maintained over 10 days due to the incorporation of MACF microparticles as compared to controls without microparticles. Importantly, we demonstrated the utility of fluorinated microparticles in reducing the number of hypoxic cells within the core regions of spheroids, while also promoting the diffusion of other small molecules in and out of these 3D in vitro models.