The newly commissioned Orion laser system has been used to study dense plasmas created by a combination of short pulse laser heating and compression by laser driven shocks. Thus the plasma density was systematically varied between 1 and 10  g/cc by using aluminum samples buried in plastic foils or diamond sheets. The aluminum was heated to electron temperatures between 500 and 700 eV allowing the plasma conditions to be diagnosed by K-shell emission spectroscopy. The K-shell spectra show the effect of the ionization potential depression as a function of density. The data are compared to simulated spectra which account for the change in the ionization potential by the commonly used Stewart and Pyatt prescription and an alternative due to Ecker and Kröll suggested by recent x-ray free-electron laser experiments. The experimental data are in closer agreement with simulations using the model of Stewart and Pyatt.

Key aspects of the technology and challenges associated with the micromoulding process are discussed. The apparent shear and extensional viscosity behaviour of a polyacetal at high wall shear rates have been measured using inline capillary rheometry on a commercial micromoulding machine and a larger servoelectric injection moulding machine; the polymer behaved predictably at shear rates in excess of 106 s -1. Initial moulding trials indicated that a stepped plaque and 0·25 mm thick rectangular plaque mouldings lled in a satisfactory manner, but a thicker plaque cavity exhibited a jetting ow into the cavity. A data capture system capable of measuring multiple process dynamics at high sampling rates (up to 50 kHz per channel) allowed detailed process measurements taken during moulding of the stepped plaque moulding. Atomic force microscopy of the moulded products showed diVerent surface nishes on each step of the stepped plaque moulding. Topography scans of the 0·25 mm thick rectangular plaque moulding showed that mould surface features with length scales of the order of a few micrometres were well replicated on the moulded product and the quality of the surface nish is dependent on the melt pressure during moulding.PRC/2020

No abstract

No abstract

Since the installation of an ITER-like wall, the JET programme has focused on the consolidation of ITER design choices and the preparation for ITER operation, with a specific emphasis given to the bulk tungsten melt experiment, which has been crucial for the final decision on the material choice for the day-one tungsten divertor in ITER. Integrated scenarios have been progressed with the re-establishment of long-pulse, high-confinement H-modes by optimizing the magnetic configuration and the use of ICRH to avoid tungsten impurity accumulation. Stationary discharges with detached divertor conditions and small edge localized modes have been demonstrated by nitrogen seeding. The differences in confinement and pedestal behaviour before and after the ITER-like wall installation have been better characterized towards the development of high fusion yield scenarios in DT. Post-mortem analyses of the plasma-facing components have confirmed the previously reported low fuel retention obtained by gas balance and shown that the pattern of deposition within the divertor has changed significantly with respect to the JET carbon wall campaigns due to the absence of thermally activated chemical erosion of beryllium in contrast to carbon. Transport to remote areas is almost absent and two orders of magnitude less material is found in the divertor.