The commercial implementation of aqueous Zn-ion batteries is being impeded by the rampant dendrite growth and exacerbated side reactions on the Zn metal anodes. Herein, a 60 nm artificial protective layer with spatial dielectric–metallic gradient composition (denoted as GZH) is developed via Zn and HfO2 cosputtering. In this design, the top HfO2 layer with high permittivity and low electronic conductivity effectively suppresses hydrogen evolution. The intermediate Zn-rich oxide region promotes the dendrite-free Zn deposition and reinforces the contact between Zn and the sputtered layer. This design allows stable battery operation at high currents. Symmetric cells with Zn-GZH exhibit stable voltage separation over 500 h at 10 mA cm–2 with a cutoff capacity of 5 mAh cm–2. When paired with a vanadate cathode, the full-cell battery delivers a capacity retention of around 75% after 2000 cycles. This design concept may apply to other aqueous metal batteries.

BackgroundLateral column tibial plateau fracture fixation with a locking screw plate has higher mechanical stability than other fixation methods. The objectives of the present study were to introduce two newly designed locking anatomic plates for lateral tibial plateau fracture and to demonstrate their characteristics of the fixation complexes under the axial loads.MethodsThree different 3D finite element models of the lateral tibial plateau fracture with the bone plates were created. Various axial forces (100, 500, 1000, and 1500 N) were applied to simulate the axial compressive load on an adult knee during daily life. The equivalent maps of displacement and stress were output, and relative displacement was calculated along the fracture lines.ResultsThe displacement and stresses in the fixation complexes increased with the axial force. The equivalent displacement or stress map of each fixation under different axial forces showed similar distributing characteristics. The motion characteristics of the three models differed, and the max-shear stress of trabecula increased with the axial load.ConclusionsThese two novel plates could fix lateral tibial plateau fractures involving anterolateral and posterolateral fragments. Motions after open reduction and stable internal fixation should be advised to decrease the risk of trabecular microfracture. The relative displacement of the posterolateral fragments is different when using anterolateral plate and posterolateral plate, which should be considered in choosing the implants for different posterolateral plateau fractures.

N6-methyladenosine (m6A) is required for differentiation of human bone marrow mesenchymal stem cells (hBMSCs). However, its intrinsic mechanisms are largely unknown. To identify the possible role of m6A binding protein YTHDF1 in hBMSCs osteogenesis in vivo, we constructed Ythdf1 KO mice and showed that depletion of Ythdf1 would result in decreased bone mass in vivo. Both deletion of Ythdf1 in mouse BMSCs and shRNA-mediated knockdown of YTHDF1 in hBMSCs prevented osteogenic differentiation of cells in vitro. Using methylated RNA immunoprecipitation (Me-RIP) sequencing and RIP-sequencing, we found that ZNF839 (a zinc finger protein) served as a target of YTHDF1. We also verified its mouse homolog, Zfp839, was translationally regulated by Ythdf1 in an m6A-dependent manner. Zfp839 potentiated BMSC osteogenesis by interacting with and further enhancing the transcription activity of Runx2. These findings should improve our understanding of the mechanism of BMSC osteogenesis regulation and provide new ideas for the prevention and treatment of osteoporosis.

The process of intervertebral disc degeneration (IVDD) is complex, and its mechanism is considered multifactorial. Apoptosis of oxidative stressed nucleus pulposus cells (NPCs) should be a fundamental element in the pathogenesis of IVDD. In our pilot study, we found that the expression of MAT2A decreased, and METTL16 increased in the degenerative nucleus pulposus tissues. Previous studies have shown that the balance of splicing, maturation, and degradation of MAT2A pre-mRNA is regulated by METTL16 m6A modification. In the current study, we aimed to figure out whether this mechanism was involved in the aberrant apoptosis of NPCs and IVDD. Human NPCs were isolated and cultured under oxidative stress. An IVDD animal model was established. It showed that significantly higher METTL16 expression and lower MAT2A expression were seen in either the NPCs under oxidative stress or the degenerative discs of the animal model. MAT2A was inhibited with siRNA in vitro or cycloleucine in vivo. METTL16 was overexpressed with lentivirus in vitro or in vivo. Downregulation of MAT2A or upregulation of METTL16 aggravated nucleus pulposus cell apoptosis and disc disorganization. The balance of splicing, maturation, and degradation of MAT2A pre-mRNA was significantly inclined to degradation in the NPCs with the overexpression of METTL16. Increased apoptosis of NPCs under oxidative stress could be rescued by reducing the expression of METTL16 using siRNA with more maturation of MAT2A pre-mRNA. Collectively, oxidative stress aggravates apoptosis of NPCs through disrupting the balance of splicing, maturation, and degradation of MAT2A pre-mRNA, which is m6A modified by METTL16.

BackgroundTibial plateau fractures are of great challenge to treat with open reduction and internal fixation, because fractures vary from simple to complex, with little or extensive articular involvement. Hence, recognition and comprehension of the fracture features will help orthopedic surgeons understand the injury mechanism better and manage these fractures by planning optimal surgical procedures. This study aimed to evaluate the morphological characteristics of tibial plateau fractures based on the Schatzker classification.MethodsA total of 186 patients with 188 tibial plateau fractures from 2010 to 2014 in our hospital were reviewed using a computed tomography scan and three-dimensional (3D) reconstruction. The main fracture line angles (FLA) of Schatzker types I, II, and IV were measured. For each fracture, depression depth was measured, and the depression zone was also located. Depression zones were overlapped to obtain a frequency diagram.ResultsSchatzker type I and II fractures had three subtypes: single anterolateral fracture, single posterolateral fracture, and complex fracture (the anterolateral and posterolateral parts). Schatzker type IV fractures were also divided into three subtypes: single posteromedial fracture, single anteromedial fracture, and the whole medial fracture. For various Schatzker types and subtypes of fracture, fracture depression clustered and occurred at different locations of the tibial plateau. A significant difference was observed in the depression depth among the different Schatzker types (P < 0.01, Kruskal-Wallis test), especially between Schatzker type III and other types (Nemenyi test). There was no difference in the depression depth among the subtypes of Schatzker type II, whereas the difference was significant between the two subtypes of Schatzker type IV.ConclusionsSchatzker type I, II, and IV fractures could be divided into three corresponding subtypes by FLA. Various Schatzker types of fractures differed in location and depth of depression. A proper operative approach should be made based on the morphological characteristics of individual types of tibial plateau fractures.