Following a potentiometric determination of the relevant pKa values of the (R1R2)C=NOH functionality, the second order rate constants (k(Ox)) for reaction of a large set of oximate bases with two model organophosphorus esters, i.e. bis-(4-nitrophenyl)phenylphosphonate (BNPPP) and bis-(4-nitrophenyl)methylphosphonate (BNPMP), and three toxic compounds, i.e., sarin (GB), soman (GD) and diisopropylphosphorofluoridate (DFP), in aqueous as well as a 30 : 70 (v/v) H2O-Me2SO mixture have been measured. The corresponding Brønsted-type nucleophilicity plots of log k(Ox)vs. pKa(Ox) reveal a clear tendency of the reactivity of the oximates to suffer a saturation effect with increasing basicity in aqueous solution. In the case of BNPMP and the three toxic esters, this behaviour is reflected in a levelling off at pKa approximately 9 but a more dramatic situation prevails in the BNPPP system where the attainment of maximum reactivity at pKa approximately 9 is followed by a clear decrease in rate at higher pKa's. Interestingly, a number of data reported previously by different authors for the sarin, soman and DFP systems are found to conform rather well to the curvilinear Brønsted correlations built with our data. Based on this and previous results obtained for reactions at carbon centers, it can be concluded that the observed saturation effect is the reflection of an intrinsic property of the oximate functionality. An explanation of this behavior in terms of an especially strong requirement for desolvation of the oximates prior to nucleophilic attack which becomes more and more difficult with increasing basicity is suggested. This proposal is supported by the observed changes in pKa(Ox) and k(Ox) brought about by a transfer from H2O to a 30 : 70 H2O-Me2SO mixture. The implications of the saturation effect on the efficiency of oximates as nucleophilic catalysts for smooth decontamination are emphasized. Also discussed is the effect of basicity on the exalted (alpha-effect) reactivity of these bases.

A study was carried out on the influence of different crown ethers on the electric percolation of AOT/isooctane/water microemulsions. The crown ethers used were chosen on the basis of two fundamental criteria:  (a) the different sizes of the molecules, where variation is found in the external size as well as the size of the cavity, and (b) the different solubilities of the ethers in water. In all cases we observed a dual behavior of the crown ethers with regard to the percolative phenomenon. At low additive concentrations we observed how the presence of the crown ethers caused an increase in the percolation temperature of the microemulsions, whereas at high additive concentrations there was a reduction in the percolation temperature causing the percolation threshold of the system to move forward. This dual behavior allowed us to define the compensation concentration, which corresponds with the crown ether concentration at which there is no effect on the percolative phenomenon. We observed a correlation between the effect exerted by the crown ethers and the size of the cavity. This shows the importance of the capacity to complexate Na+ and solubilize it in the interface and the continuous medium on the electric percolation. We also observed a correlation between the effect of the crown ethers on the percolation temperature and their external size. This shows the importance of their inclusion in the interface on the percolative phenomenon. Such an inclusion modifies the properties of the AOT film, facilitating the exchange of matter between droplets. We also obtained a satisfactory multiparametric correlation between the logarithm of the compensation concentration, the logarithm of the distribution parameter of the crown ether between water and 1-octanol, and the number of oxygen atoms in the crown ether. This correlation shows that the effect of the crown ethers on the electric percolation is due to its size and capacity to sequester ions, as well as to its solubility in the interface of the microemulsion.

The basic hydrolysis of crystal violet (CV) in mixed systems consisting of beta-cyclodextrin (beta-CD) and a micelle-forming surfactant, cetyltrimethylammonium chloride (CTACl), has been studied. beta-CD was found to catalyze the basic hydrolysis of CV through the interaction of its hydroxyl group, in its deprotonated form, with the carbocation in the complexed substrate. The addition of small amounts of CTACl, with [CTACl] below the critical micelle concentration, to beta-CD solutions does not have an effect upon the observed rate constant for the basic hydrolysis of CV. This behavior is different from that observed for the alkaline hydrolysis of N-methyl-N-nitroso-p-toluenesulfonamide and nitrophenyl acetates in mixed beta-CD/cationic surfactant systems. The proposed mechanism allows us to explain the experimental results on the basis of the high percentage of uncomplexed beta-CD in equilibrium with the micellar system, the low CV concentration, and the high value for the binding constant of CV by beta-CD.

The kinetics of nucleophilic dephosphorylation of p-nitrophenyl diphenyl phosphate by hydroxamate ions (R'(C=O)N(RO-)) have been investigated in aqueous cationic micellar media at pH 9.12 and 27 degrees C. The pseudo-first-order rate constant-surfactant profiles show micelle-assisted bimolecular reactions involving interfacial ion exchange between bulk aqueous media and micellar pseudophase. N-Substituted hydroxamate ion shows higher reactivity over the unsubstituted hydroxamate ions in cationic micellar media. The kinetic data are discussed in terms of the pseudophase ion exchange model.

The influence of the nature of the continuous medium on various properties of a wide range of water‐in‐oil (w/o) microemulsions was examined. 1H NMR spectroscopy allowed to determine the properties of water in the studied systems and the way they are affected by the solvent to be elucidated. Changes in interfacial polarity were examined from the 13C NMR signals of the surfactant molecule sodium bis(2‐ethylhexyl)sulfosuccinate (AOT). Chemical shifts were found to vary with the water content of the microemulsion. The variation of the carbon chemical shift as a function of the water‐to‐surfactant concentration ratio (W) was used as an indirect measure of polarity changes at the microemulsion interface. The kinetic effects of the microemulsion composition on the solvolysis of anisoyl chloride were studied, and the reagent was found to react with water at the microemulsion interface alone. Based on both kinetic and NMR results, the solvolysis rate constants of anisoyl chloride decrease with increasing penetration of the oil into the interface. Also, the resonance signals for the water H atoms were found to change in parallel with the solvolysis rate constant for anisoyl chloride. (© Wiley‐VCH Verlag GmbH & Co. KGaA, 69451 Weinheim, Germany, 2006)

The effect of micellar aggregates upon the stability of carbofuran in basic media has been studied. The effect of the presence of micelles upon the basic hydrolysis of carbofuran is a function of the nature of the surfactant monomer. Important catalysis of basic hydrolysis of carbofuran in the presence of colloid aggregates with positive surface charge has been reported. On the other hand, the presence of anionic and nonionic surfactants implies a large inhibition of the basic hydrolysis of carbofuran. Both catalysis and inhibition are due to the association of carbofuran with the micellar core. The kinetic constants for the basic hydrolysis of carbofuran in these microheterogeneous media have been obtained on the basis of a micellar pseudophase model. No significant changes in the intrinsic reactivity of HO- against carbofuran have been observed.

Replacing the counterion in sodium bis(2-ethylhexyl)sulfosuccinate (NaOT, usually known as AOT or Aerosol OT) with H+ (HOT) allows strongly acidic microemulsions to be obtained through the effect of a change in the solvation mechanism of the surfactant, where the Na+...OH2 interaction is displaced by a stronger H+...OH2 interaction. This raises the proportion of water bound to the counterion, which is reflected in the FT-IR spectrum for water trapped in the microemulsion and the 1H NMR spectrum for the hydrogen atoms in the water molecules. In NaOT microemulsions, the resonance signal for hydrogen atoms in the water molecules increases from delta approximately 3.9 ppm at W = 2 (with W = [H2O]/[NaOT]) to delta approximately 4.8 ppm at W = 50. In HOT microemulsions, the disparate strength of Na+...OH2 and H+...OH2 interactions results in a decrease in the resonance signal for the hydrogen atoms in the water molecules from delta approximately 8.6 ppm at W = 2 to delta approximately 4.9 ppm at W = 50. These changes in the physical properties of water alter chemical reactivity in a way that is clearly apparent in solvolytic processes in NaOT and HOT microemulsions. Thus, the rate constants of reactions involving an associative mechanism increase with decreasing W in NaOT microemulsions, but decrease with decreasing W in HOT microemulsions. The disparate behavior is a result of a decreased nucleophilicity of interfacial water in HOT microemulsions relative to NaOT microemulsions. For a dissociative process the rate constants are greater in HOT microemulsions than in NaOT ones, and increase with increasing W in both types of microemulsions, which can be ascribed to an increased electrophilicity of interfacial water in HOT microemulsions.

The self-aggregation behavior of the double-chained ionic liquid (IL) 1,3-didecyl-2-methylimidazolium chloride ([C10C10mim]Cl) in aqueous solution has been investigated with a number of different experimental techniques. Two cmc values (cmc1 and cmc2) are obtained from conductivity measurements. The fraction of neutralized charge on the micellar surface suggests that cmc1 corresponds to the formation of spherical micelles and cmc2 to the transition from spherical to cylindrical micelles. Data obtained from fluorescence spectroscopy (using pyrene and Nile red as chemical probes), fluorescence anisotropy (using rhodamine B as probe), and chemical shift (1)H NMR (in D2O) provide a picture that is also consistent with a sphere-to-cylinder transition. This structural change is further confirmed by diffusion-ordered NMR spectroscopy (DOSY), from the self-diffusion coefficients for surfactant unimer and aggregates. Furthermore, a third evolution from cylindrical micelles to bilayer aggregates is proposed from the analysis of diffusion coefficients at high surfactant concentration ([IL] > 0.2 M). Phase scanning experiments performed with polarized light microscopy clearly demonstrate the presence of a lamellar liquid crystalline phase at very high IL concentration, thus confirming the coexistence of bilayer structures with elongated micelles, found at lower concentration. Additionally, [C10C10mim]Cl micelles are proposed as novel reaction media, as evidenced by the solvolysis reaction of 4-methoxybenzenesulfonyl chloride (MBSC).