When a dry soluble polymer is put in contact with a large quantity of solvent, it swells and forms a transient gel, and eventually, yields a dilute solution of polymers. Everyday lab experience shows that when the molar mass is large, namely tens of times larger than entanglement mass, this dissolution process is slow and difficult and may require stirring. Here, in agreement with previous results, we found that the time needed to turn a dry grain into a dilute solution is not limited by water diffusion in the glassy or semi-crystalline dry polymer, but rather by the life-time of the transient gel made of entangled chains. In addition, we shed new light on the dissolution process by demonstrating that, in contrast to theoretical predictions, the gel life-time is not governed by reptation. We show instead that swelling is simply controlled by the osmotic pressure and the gel permeability until the overlap concentration is reached within the gel. At this stage, the gel turns into a dilute solution in which polymers are dispersed by natural convection. The observed dependence of the dissolution process on the molar mass therefore originates from the molar mass dependent overlap concentration. Under stirring, or forced convection, the polymer gel disappears at a higher critical concentration that depends on the shear rate. We suggest a description of the experimental data which uses the rheological flow curves of the solutions of the considered polymer. Inversely, dissolution times of polymer powders under stirring can be inferred from classical rheological measurements of the polymer solutions at varied concentrations.
We review the studies on the wetting of soluble polymeric substrates by their solvents, both in the literature and conducted in our group in the past decade. When a droplet of solvent spreads on a soluble polymer layer, its wetting angle can strongly vary with the contact line velocity even at capillary numbers smaller than unity, in contrast to non-soluble substrates. The solvent content in the polymer is a key parameter for the spreading dynamics; that content is set by the initial conditions, but also by the transfers occurring from the droplet to the polymer layer during spreading. We focus on hydrophilic amorphous polymers that are glassy at room temperature, and we discuss the consequences on wetting of the very large changes in the polymer physical properties induced by solvent sorption. We finally present new results on polymers of varying molar masses, and show how they open new perspectives for a better understanding of powder dissolution.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.