No abstract

Optimization of Nannochloropsis oculata growth was undertaken using the response surface method. A central composite design was defined to study the effects of temperature, pH, incident light intensity and aeration rate on the maximum growth rate of the microalga. Using statistical analysis, the first model calculated to fit results was twice improved. The final model obtained was used to clarify the effects of each factor and their interactions on the growth of Nannochloropsis oculata. The optimum growth conditions of this microorganism were also estimated as 21• C, 52 µmol photons m −2 s −1 , pH 8.4 and 14.7 VVH of aeration rate. These conditions were tested and validated experimentally since the maximum growth rate achieved with these parameters, 0.0359 h −1 , is the best reported in this study.

Hugues. Relationship between bioleaching performance, bacterial community structure and mineralogy in the bioleaching of a copper concentrate in stirred-tank reactors. Applied Microbiology and Biotechnology, Springer Verlag, 2011, 89 (2) The experiments undertaken to produce the techno-economic data were also an opportunity to carry out more fundamental research. The objective of this work was to combine the results of the bioleaching experiments, in terms of copper recovery, with the results of bacterial community monitoring and mineralogy residue analysis.Batch and continuous bioleaching tests were carried out with 10% solids, at 42 °C and with a pH between 1.2 and 1.6. Final copper recovery was higher in batch cultures than in continuous mode (>95% vs. 91%). Mineralogical analysis showed that the limiting factor for copper recovery was incomplete chalcopyrite dissolution in both cases. However, chalcopyrite was even less dissolved in continuous conditions. This was also related to a variation in bacterial community structure. The population in all tests was composed of Acidithiobacillus caldus, Leptospirillum ferriphilum and one or two species of Sulfobacillus (thermosulfidooxidans and sometimes benefaciens) but Sulfobacillus and more generally sulphur oxidizers were more represented in batch mode.It was proposed that, due to their capacity to reduce inorganic compounds, sulphur oxidizers may be efficient in limiting chalcopyrite surface hindering. It may help to better dissolve this mineral and reach a better copper recovery.

No abstract

In this study, we investigate exopolysaccharide production by a bacterial consortium during the bioleaching of a cobaltiferrous pyrite. Whereas comparable studies have looked at exopolysaccharide production in batch systems, this study focuses on a continuous system comprising a series of four stirred bioreactors and reveals the difficulties in quantifying biomolecules in complex media such as bioleached samples. We also adapted the phenol/sulphuric acid method to take into account iron interference, thus establishing a new protocol for sugar quantification in bioleached samples characterised by low pH (1.4) and high iron concentration (2 g l(-1)). This allows sugar analysis without any prior sample preparation step; only a small amount of sample is needed (0.5 ml) and sample preparation is limited to a single filtration step. We found that free exopolysaccharides represented more than 80% of the total sugars in the bioreactors, probably because stirring creates abrasive conditions and detaches sugars bound to pyrite or bacteria and that they were produced mainly in the first two reactors where bioleaching activity was greatest. However, we could not establish any direct link between the measured exopolysaccharide concentration and bioleaching activity. Exopolysaccharides could have another role (protection against stress) in addition to that in bacterial attachment.